Sony MDR-RF5000K Operating Instructions - Page 23
Troubleshooting, Additional Information - problems
![]() |
View all Sony MDR-RF5000K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
1 Additional Information Troubleshooting If you run into any problems using this headphone system, use the following checklist. Should any problem persist, consult your nearest Sony dealer. Symptom No sound Cause and remedy , Check the connection between the transmitter or and the AV component. , Check that the signal is not being input to the digital out jack by mistake when digital input is selected. , Check that the connected AV component's optical digital output is set to "ON" when selecting digital input. , Make sure that optical digital output of a connected AV component is set to PCM. (Excessive noise may occur if signals other than PCM are input to this unit.) , Turn on the AV component connected to the transmitter, and start the playback. , Check that the INPUT SELECT switch on the transmitter is set to the component you want to listen to. , If you connect the transmitter to an AV component using the headphone jack, raise the volume level on the connected AV component. , Make sure you are wearing the headphones correctly. , Raise the headphone volume. , The headphones' POWER indicator goes off. • Charge the rechargeable battery if it is weak, or replace alkaline batteries with new ones. If the POWER indicator is still off after charging the battery, take the headphones to a Sony dealer. , You are playing back a DVD disc recorded in DTS when the DVD device (including game machines) and the transmitter are analog-connected. • Use the digital connection. (Analog sound may not be output from the DVD device.) , The transmitter's ID is not set for the additional headphones. , Additional headphones are being charged. • Remove additional headphones from the transmitter. (Continued) Additional Information 23US
![](/manual_guide/products/sony-mdrrf5000k-operating-instructions-08b0a6c/23.png)