Sony MXD-D3 Users Guide - Page 9
Basic Operations, Do not disconnect the deck from the power source immediately after, recording
![]() |
View all Sony MXD-D3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Basic Operations Notes • You cannot record over existing material during CD SynchroRecording. The deck automatically starts recording from the end of the existing material. • Make sure that the remaining recordable time on the MD is longer than the playing time of the CD, especially if you want to record all the tracks on the CD. • You cannot pause recording during CD Synchro-Recording. • The recording level specified in the Setup Menu (page 20) is not applied during CD SynchroRecording. The initial reference level (0.0 dB) is used instead. When "TOC Writing" flashes in the display The deck is currently updating the Table Of Contents (TOC). Do not move the deck or pull out the AC power cord. Changes to an MD made through recording are saved only when you update the TOC by ejecting the MD or changing the deck to standby by pressing the 1/u switch. Do not disconnect the deck from the power source immediately after recording If you do, recorded material may not be saved to the MD. To save the material, after recording, press § EJECT to take out the MD or change the deck to standby by pressing 1/u. "TOC Writing" will flash at this time. After "TOC Writing" goes out, you can pull out the AC power cord. To protect an MD against accidental erasure To make it impossible to record on an MD, slide the tab in the direction of arrow, opening the slot. To allow recording, close the slot. Record-protect tab Rear of the disc Slide the tab in the direction of arrow Basic Operations 9
![](/manual_guide/products/sony-mxdd3-users-guide-0be4e79/9.png)