Sony PCG-818 User Guide - Page 2
Safety, Information, Regulatory
View all Sony PCG-818 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Safety Information Owner's Record The model number and serial number are located on the bottom of your Sony VAIO Notebook Computer. Record the serial number in the space provided here. Refer to the model and serial number when you call your Sony Service Center. Model Number: PCG-818 Serial Number: WARNING -1 To prevent fire or shock hazard, do not expose your notebook computer to rain or moisture. 3 To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. J Never install modem or telephone wiring during a lightning storm. J Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations J Never touch uninsulated telephone wire or terminals unless the telephone line has been disconnected at the network interface. J Use caution when installing or modifying telephone lines. J Avoid using the modem during an electrical storm. J Do not use the modem or a telephone to report a gas leak in the vicinity of the leak. -1 A socket outlet should be as close as possible to the unit and easily accessible. I The laser beam used in the DVDROM drive unit is harmful to the eyes. Do not attempt to disassemble the cabinet. Refer servicing to qualified personnel only. AVERTISSEMENT J Pour prevenir tout risque d'incendie ou d'electrocution, garder cet appareil a l'abri de la pluie et de l'humidite. 3 Pour prevenir tout risque d'electrocution, ne pas ouvir le chassis de cet appareil et ne confier son entretien qu'a une personne qualifiee. J L'appareil doit etre le plus pros possible d'une prise murale pour en faciliter l'acces. Regulatory Information Declaration of Conformity Trade Name: SONY Model No: PCG-818 Responsible Party: Sony Electronics Inc. Address: 1 Sony Drive Park Ridge, NJ 07656 Telephone No.: 201-930-6970 This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular