Sony RCD-W2000ES Operating Instructions (primary manual) - Page 40

DECK B (the CD-R and CD-RW recording section) The unit does not operate or operates poorly. • The CD-R or CD-RW may be damaged. Replace the disc. The player does not start playing. • Place the CD-R or CD-RW with the label side up. • Moisture has formed inside the unit. Take the disc out and leave the unit in a warm place for several hours until the moisture evaporates (page 4). • Press POWER to turn the unit on. • Replace the CD-R or CD-RW with one that has been recorded. The player does not start recording. • The CD-R or CD-RW is finalized. Unfinalize (for CD-RW only) the disc (page 31) and try again. • Make connections properly to the sound source (page 6). • The sound source is not connected to the selected input connector. Select the correct input using the INPUT button (page 27). • The recording level is set too low. Adjust the recording level properly (page 28). • There has been a power failure or the AC power cord has been disconnected during recording. Data recorded to that point may be lost. The sound has a lot of static. Strong magnetism from a television or a similar device is interfering with operations. Move the unit away from any sources of strong magnetism. MP3 files cannot be played back. • You cannot play MP3 files on DECK B. Other No sound is output. • Make the connections properly (page 6). • Operate the amplifier properly. • When using the headphones, turn PHONE LEVEL to turn up the output level. • Check the DUAL MODE setting. When the DUAL MODE is activated, the unit outputs the sound of DECK A to OUT 1 jacks and that of DECK B to OUT 2 jacks (page 20). The remote does not operate the unit. • Make sure that there are no obstacles between the unit and the remote. • Point the remote at the remote sensor on the unit. • Replace the batteries in the remote. When you turn on the unit, you will hear some mechanical noise from the unit. This is not a malfunction. After you have attempted the prescribed corrective actions If the unit still does not operate properly, or if other problems not described above occur, turn off the unit, unplug it from the power outlet for a few minutes, then reinsert the plug into the power outlet. Should any problem persist even after reinserting the power plug, consult your nearest Sony dealer. 40