Sony RDHSK8IP Operating Instructions - Page 14

LOCK 7 Place back the "L" ring by matching the "b L" on the ring with "L B" on the acrylic plate. Then, turn the ring in the "LOCK" arrow direction until it locks. Acrylic plate LL "L" ring Notes • Make sure the rib of the ring is horizontally parallel after you place back the ring. Otherwise, the ring is not attached to the front panel securely. • Make sure the "R" ring is attached to the right of the front panel and the "L" ring is attached to the left of the front panel. Customizing the graphic sheet You can also create your own graphic sheet. Prepare the paper material (posters, newspapers, printing, handmade graphic arts, etc.). After you have prepared the paper material, we recommend you to use the acrylic plate as a template to draw the outline of the custom graphic sheet. Then, trim the graphic sheet according to the outline. Troubleshooting Should you encounter a problem with your unit, do the following: 1 Make sure the AC power cord (mains lead) is connected correctly and firmly. 2 Find your problem in the troubleshooting checklist below and take the indicated corrective action. If the problem persists after doing all of the above, consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained. When the indicator does not stop flashing Immediately turn off the unit and unplug the AC power cord (mains lead). Then perform the following items. • Remove anything that is blocking the ventilation hole. • Disconnect the iPod/iPhone. • Disconnect audio cord from the AUDIO IN jack. After performing the above items and fixing any problems, plug in the AC power cord (mains lead) again and turn on the unit. If the indicator still flashes, or if the cause of the problem cannot be found even after performing all the above items, consult your nearest Sony dealer. 14GB