Sony RM-AX1400 Operating Instructions - Page 10

Setting up for your PC (continued) 4 Click [Next]. Follow the on-screen instructions and proceed with the installation. When the installation is complete, "AX1400 Remote Editor 1.0 Setup" automatically quits. Tip If the installation screen is hidden behind other windows If "AX1400 Remote Editor 1.0 Setup" disappears behind other screen while installing, press the [Tab] key several times while pressing down the [Alt] key to bring up "AX1400 Remote Editor 1.0 Setup" again. Installing the USB driver You need to install the USB driver before connecting the supplied Dedicated USB cable to your PC and the Remote Commander. Follow the instructions below to install. Notes • Without batteries in the Remote Commander, the USB connection cannot be detected by the PC even if the Dedicated USB cable is connected. • Make sure to install the batteries before installing the USB driver. If the USB driver installation is interrupted by mistake, install it again from the beginning. • Do not simply copy the USB driver in the supplied CD-ROM to the PC. You need to install it properly for it to work. • Administrator privileges are required for installation on PCs running Windows 2000 or Windows XP. • On Windows 2000 or Windows XP, you need to install the driver for each port to which the Remote Commander will be connected. • Depending on the PC, various messages other than those mentioned in this manual may appear during the USB driver installation. Just follow the on-screen instructions of these messages to install. For Windows XP users 1 Close all software running on Windows. 2 Insert the supplied CD-ROM into the CD-ROM drive of the PC. After a moment, "RM-AX1400 Install CD Menu" appears. 3 Click [Exit] to close "RM-AX1400 Install CD Menu." 4 Connect the PC and the Remote Commander using the supplied Dedicated USB cable (page 11). "Found New Hardware" appears in the Notification Area in the lower right-hand of the display. After a moment, "Found New Hardware Wizard" appears. Tip If the following confirmation message "Can Windows connect to Windows Update to search for software?" appears, select [No, not this time], then click [Next]. 5 Select "Install the software automatically [Recommended]", then click [Next]. Installing of the USB driver starts. "Completing the Found New Hardware Wizard" appears when the installation is complete. 6 Click [Finish]. Installing of the USB driver finishes. 10