Sony RM-VL610A Operating Instructions (RM-VL610A Remote Commander®) - Page 11
Press the Component Select, button for the desired, component., Press the Number buttons
View all Sony RM-VL610A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
3 Press the Component Select button for the desired component. The SET indicator and the selected Component Select button lights up. Notes • If you press a component code number that is not on the table in the supplied "Component Code Numbers," or if you press a button in the wrong order, the Component Select button flashes five times, and then turns off. Check the component code number, and try setting it again. • If you don't input anything into the Commander within 20 seconds between each step, the setup procedure will be canceled. To set the code, start over from Step 2. • If you press SET while setting the component code, all code numbers will be lost, and the setup procedure will be canceled. Start over from Step 2. To cancel setup, press SET. 4 Press the Number buttons to enter the four-digit component code number. 5 Press ENT. The SET indicator and the Component Select button light turns off. If the Component Select button flashes five times before turning off, it means that the setup is incomplete. Start over from Step 2. Continued 11