Sony SDM-S204 Operating Instructions (primary manual) - Page 9

If no picture appears on your screen • Check that the power cord and the video signal cable are properly connected. • If "NO INPUT SIGNAL" appears on the screen: - The computer is in the power saving mode. Try pressing any key on the keyboard or moving the mouse. - Check that the input signal setting is correct by pressing the INPUT button (page 10). • If "CABLE DISCONNECTED" appears on the screen: - Check that the video signal cable is properly connected. - Check that the input signal setting is correct by pressing the INPUT button (page 10). • If "OUT OF RANGE" appears on the screen, reconnect the old monitor. Then adjust the computer's graphics board within the following ranges. Horizontal frequency Vertical frequency Resolution Analog RGB 28-92 kHz Digital RGB 28-75 kHz 48-85 Hz 60 Hz 1600 × 1200 or less For more information about on-screen messages, see "Trouble symptoms and remedies" on page 20. No need for specific drivers The monitor complies with the "DDC" Plug & Play standard and automatically detects all the monitor's information. No specific driver needs to be installed on the computer. The first time you turn on your computer after connecting the monitor, the setup Wizard may appear on the screen. In this case, follow the on-screen instructions. The Plug & Play monitor is automatically selected so that you can use this monitor. The vertical frequency is set to 60 Hz. Since flickers are unobtrusive on the monitor, you can use it as it is. You do not need to set the vertical frequency to any particular high value. Setup 5: Adjust the tilt This monitor can be adjusted within the angles shown below. Grasp the sides of the LCD panel, then adjust screen angles. approx. approx. 5° 20° GB approx. 175° approx. 175° To use the monitor comfortably Adjust the viewing angle of your monitor according to the height of your desk and chair, and so that light is not reflected from the screen to your eyes. Note When adjusting the screen tilt, proceed slowly and carefully, being sure not to hit the monitor against the desk. 9