Sony SDM-S71 Operating Instructions (primary manual) - Page 18
Troubleshooting, On-screen messages - problems
View all Sony SDM-S71 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Troubleshooting Before contacting technical support, refer to this section. On-screen messages If there is something wrong with the input signal, one of the following messages appears on the screen. To solve the problem, see "Trouble symptoms and remedies" on page 19. If OUT OF SCAN RANGE appears on the screen This indicates that the input signal is not supported by the monitor's specifications. Check the following items. I NFORMA T I ON OUT OF SCAN RANGE x x . x kHz / x xHz If CABLE DISCONNECTED appears on the screen This indicates that the video signal cable has been disconnected from the currently selected connector. I NFORMA T I ON CAB L E D I SCONNECT ED GO TO POWER SAVE GO TO POWER SAVE The monitor will enter the power saving mode after about 5 seconds from the message is displayed. If "xx.x kHz/xx Hz" is displayed This indicates that either the horizontal or vertical frequency is not supported by the monitor's specifications. The figures indicate the horizontal and vertical frequencies of the current input signal. If "RESOLUTION > XGA" is displayed (SDM-S51) This indicates that the resolution is not supported by the monitor's specifications. If "RESOLUTION > SXGA" is displayed (SDM-S71/ S81) This indicates that the resolution is not supported by the monitor's specifications. If NO INPUT SIGNAL appears on the screen This indicates that no signal is input. I NFORMA T I ON NO I NPUT S I GNA L GO TO POWER SAVE GO TO POWER SAVE The monitor will enter the power saving mode after about 5 seconds from the message is displayed. 18