Sony SRPX700P Product Manual (SRP-X700P Hardware Operation Manual 1.3) - Page 10
REMOTE PARALLEL Terminal
View all Sony SRPX700P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
How to Control the SRP-X700P from External Equipment REMOTE PARALLEL Terminal The REMOTE PARALLEL terminal enables the SRP-X700P to be remotely controlled with a simple circuit connected externally to this terminal. (D-sub 25-pin, female) Terminal shape Recommended cable Cable length : D-sub 25-pin, female : Multi-core shielded cable for data communication : 50 m or less INPUT terminal You can set the functions of the respective terminals from the PARALLEL INPUT FUNCTION setup box in the REMOTE screen of the supplied SRP-X700P Manager software. All faders and sound volume controls can be controlled from a remote location by connecting a variable resistor as shown, in the range of 0 to -∞ dB. You can perform the following operations by adding a make contact. • Input selection of LINE 4 system • Muting • Scene recall • Sound volume adjustment (Up/Down) • Controlling the AV equipment connected to the CONTROL S terminal • Power-ON/STANDBY selection of a projector OUTPUT terminal The turning ON conditions of the respective pins of the OUTPUT terminal can be set from the following. • Input selector state of LINE 4 system • Turning ON the OVER and -∞ indicators • Turning ON the scene recall button • Generation of the Power-ON/STANDBY command of a projector You can select the ON conditions from the PARALLEL OUTPUT FUNCTION setup box on the REMOTE screen of the supplied SRP-X700P Manager software. SRP-X700P Input terminal (No. 2 to No. 13) 0 dB GND (Nos. 1, 14 and 25) -∞ dB 10 kΩ Curve-B variable resistor SRP-X700P Input terminal (No. 2 to No. 13) GND (Nos. 1, 14 and 25) SRP-X700P Output terminal (No. 15 to No. 24) 40 mA MAX N LED 24 V GND MAX (Nos. 1, 14 and 25) Pin No. Function 1 GND 2 INPUT1 3 INPUT2 4 INPUT3 5 INPUT4 6 INPUT5 7 INPUT6 8 INPUT7 9 INPUT8 10 INPUT9 11 INPUT10 12 INPUT11 13 INPUT12 14 GND 15 OUTPUT1 16 OUTPUT2 17 OUTPUT3 18 OUTPUT4 19 OUTPUT5 20 OUTPUT6 21 OUTPUT7 22 OUTPUT8 23 OUTPUT9 24 OUTPUT10 25 GND Notes • Do not apply any reverse voltage across the output terminal. • Do not connect the shield cable of the REMOTE wire and the GND wire to the terminal table or the like. It can cause malfunction and noise. • Install the REMOTE cable away from the dimmer, motor and others. • When the PARALLEL input terminal is used to set the projector power to either the power-ON state or to the power-STANDBY state, the projector power enters the power-ON state when the PARALLEL input is set to ON. The projector power enters the power-STANDBY state when the PARALLEL input is set to OFF. Therefore, use an alternate type switch for power control. 10