Sony SRPX700P Product Manual (SRP-X700P Hardware Operation Manual 1.3) - Page 13

System example when external operation panel and environment equipment are connected 13 MD recorder VHS VCR IR transmitter DVD player S VIDEO VIDEO R/G/B/HD/VD Y/R-Y/B-Y RS-232C or CONTROL S External operation panel LCD data projector To power outlet Front speaker (L) Front speaker (R) ANT IN a DC 9V OUT 35mA MAX S VIDEO VIDEO LINE4 INPUT COMPONENT/RGB ANT IN b DC 9V OUT 35mA MAX LINE3 IN L R A B C L L R R FRONT D REAR L R CENTER FRONT E REAR L WOOFER R CENTER WOOFER F L R 1 +48V 2 +48V MIC INPUT 3 +48V 4 +48V MIC5/LINE1 IN (+48V) MIC LINE ON OFF ON OFF ON OFF ON OFF OUTPUT S VIDEO VIDEO R/R-Y G/Y B/B-Y SYNC/HD VD CONTROL S OUTPUT 1 3 PROJECTOR CONTROL CONTROL S IN RS-232C CH-2 IMPEDANCE USE 4-16 SPEAKERS CH-1 IMPEDANCE USE 4-16 PARALLEL 70V LINE IMPEDANCE USE 32 -10k REMOTE RS-232C 2 4 OUT MIC6/LINE2 IN (+48V) MIC LINE LINE OUTPUT REC OUT 3 5 7 1 1 2 4 6 8 2 AC IN CIRCUIT BREAKER PUSH RESET USER CONTROL PANEL USB Surround speaker (LS) Surround speaker (RS) Component 5.1 channel surround Operation terminal Power amplifier Center speaker (C) To power outlet RS-232C External system controller Sub woofer (SW) CD player I/F BOX Screen I/F BOX Curtain I/F BOX Illumination Power amplifier Ceiling speaker PC 1 RGB AUDIO PC 2 RGB AUDIO Power amplifier • You can control the SRP-X700P from a remote location by one of the three methods (either from the User Control Panel or from the external operation panel or from external system controller.) • You can control the SRP-X700P and the equipment connected to the SRP-X700P by sending command from external system controller to the SRP-X700P. (The system controller software is separately necessary.) • If you use a projector that is controlled through the CONTROL S terminal, the RGB signal equipment and the component signal equipment cannot be mixed in the system connection. The component signal output equipment such as DVD should use the 4A to 4C LINE 4 INPUT terminals connecting the video or S video signal. • The system configuration shown above uses the two unit of the UHF synthesizer tuner unit WRU-806B (option). • If you want to use an electret condenser microphone for MIC3 and MIC4, set the +48 V button of the corresponding channel to ON. • Install the IR transmitter VM-50 in the SRP-X700P or in the location inside a rack that allows its receptor block to receive the remote control signal. For the installation of the VM-50, see "How to Control AV Equipment from the SRP-X700P" on page 11. • If you want to control the environment equipment such as screen, curtain and illuminations from the REMOTE PARALLEL output terminal, use the optional interface box (I/F box). • For the external operation panel and interface box (I/F Box), see "System example when operating the SRP-X700P from the REMOTE PARALLEL terminal" on page 14.