Sony SRXT420 User Manual (SRX-T420 user manual) - Page 56
Connecting the Projector
View all Sony SRXT420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Chapter 2 Preparations Connecting the Projector When you connect the projector, make sure to: • Turn off all equipment before making any connections. • Use the proper cables for each connection. • Insert the cable plugs firmly; loose connections may increase noise and reduce performance of picture signals. When pulling out a cable, be sure to pull it out from the plug, not the cable itself. • When installing the optional input board, consult your Sony dealer. • For connecting the cable to the connector inside the projector, consult your Sony dealer. Refer also to the instruction manuals of the equipment to be connected. Connecting a Computer Equipped with a DVI-D Connector Connect a computer with a DVI-D connector to the optional LKRI-005 HDCP DVI input board attached to any of INPUT A to INPUT D inside the projector. HDCP (High-bandwidth Digital Content Protection) DVID signal can also be input when the input signal with specified resolution is input from LKRI-005. For details, refer to the Operating Instructions of LKRI005. Notes • According to the input signal type, set "Signal Mode" on "Input Source" in the PICTURE CONTROL window of the SRX Controller. (page 62) • When an extension cable is used, the signal may not be input correctly due to signal reduction. • If you input 10-bit signals from a DVI-D connector only (10-bit single mode), a DVI cable compatible with the Dual-link is required. Connecting an HD-SDI Equipment Attach the optional LKRI-003 HD-SDI input board inside the projector and connect an HD-SDI equipment to the connectors on the attached input board. DVI cable (not supplied) DVI-D connector AUX connector Computer 56 Connecting the Projector HD-SDI connecting cable (not supplied) to HD-SDI output HD-SDI equipment, etc. Note When the LKRI-003 is attached to the projector, select the type of signal with "Signal Mode" of "Input Source" in the