Sony SRXT420 User Manual (SRX-T420 user manual) - Page 65
INSTALLATION Window
View all Sony SRXT420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
INSTALLATION Window The INSTALLATION window is used to adjust the projected picture and to change the lamp output, etc. Off: Normal projection H: Flips the picture horizontally V: Flips the picture vertically HV: Flips the picture horizontally and vertically Off H Chapter 4 Adjustments and Settings Using the SRX Controller LENS CONTROL Adjusts the projected picture on the screen. Zoom +/-: Adjusts the size of the picture. Clicking enlarges the picture size, and reduces the picture size. Focus +/-: Adjusts the picture focus. Clicking focuses on a picture further back. Clicking focuses on a forward picture. ELECTRIC V SHIFT FUNCTION Adjusts the vertical position of the projected pictures electrically. As the setting value increases, the picture moves upward. As the setting value decreases, the picture moves downward. Clicking the "RESET" button resets the setting to the factory-preset values. Notes • This function is effective in the following cases: - When single-screen mode is selected - When quad-screen mode is selected and "PROGRESSIVE DISPLAY MODE" is set to "On" • When this function is used for quad-screen mode, all the projected signals should be genlocked to synchronize with each other with a phase difference of less than 5 µsec. If they are not synchronized, the picture is not displayed correctly. IMAGE FLIP Flips the picture. Select it from the drop-down list displayed by clicking according to the installed condition of the projector. V HV PROGRESSIVE DISPLAY MODE Normally, click the "Off" radio button. Click the "On" radio button when the signals from four input boards are used to project a 2048 (1920) × 1080-pixel signal as a 4096 (3840) × 2160-pixel 4K image or to project a 1400 × 1050-pixel (SXGA+) signal as a 2800 × 2100-pixel image in single-screen mode. SQUEEZE This function allows the input signal to be displayed on the screen in a converted aspect ratio. When you click the "On" radio button, the 720p, 1920 × 1080 or 2048 × 1080 signal with a 16:9 aspect ratio can be displayed by stretching to a 2.39:1 aspect ratio. When you click the "Off" radio button, the input signal is displayed without converting the aspect ratio. Note This function is available only for projection in singlescreen mode. LAMP POWER Adjusts the lamp power output. Lamp Power: You can reduce the lamp power to a value from 53% to 100% in increments of 1% using the or button. 65 INSTALLATION Window