Sony STR-DA3400ES Operating Instructions (Large File - 15.18 MB) - Page 128
Setting remote control codes that are not stored in the remote, To cancel learning
View all Sony STR-DA3400ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Setting remote control codes that are not stored in the remote Even if a remote control code is not one of the presets stored in the remote, it is possible for the remote to learn the code using the learning function. Note When setting up the receiver to learn the remote command modes, replace the batteries with new ones. 1,6 1 3 2,3 THEATER SHIFT TV ZONE AMP 1 2 3 TV INPUT VIDEO1 VIDEO2 BD DVD 4 SAT 7 TUNER -/-- 5 TV 8 PHONO 0/10 6 WIDE MD/ TAPE SA-CD/ CD 9 D.TUNING MULTI IN DMPORT ENT/MEM CLEAR HDMI1 HDMI2 HDMI3 HDMI4 ?/1 XM SIRIUS 2CH/ A.DIRECT A.F.D. SOURCE MOVIE MUSIC Example for assigning numeric button 1 to VIDEO 1 of the remote: 1 While holding down RM SET UP, press THEATER. The RM SET UP button lights up. 2 Press the input button (VIDEO 1 in the example) for which you want to use the Learning input function. The input button flashes. (The RM SET UP button remains lit.) 3 Press SHIFT and then press the numeric button (button 1 in the example) you want to use as the VIDEO 1 button. The input button you selected in step 2 lights up. (The RM SET UP button remains lit.) 4 Point the remote code receiver section of the remote towards the receiver/transmitter on the remote control to be learned from. While the second remote is receiving the signal, the input button selected in step 2 turns off. About 5 cm - 10 cm (2" - 4") 5 The RM SET UP button flashes twice, then the learning process is completed. When the learning process fails, the RM SET UP button flashes five times. Try to perform the process again from step 2. 6 Press RM SET UP to finish the Learning function process. Tips • When the memory capacity for storing remote control codes reaches a certain limit, the RM SET UP button flashes 10 times, and then the learning process ends. • If the RM SET UP button flashes five times in step 1, and the learning process does not start, replace the batteries with new ones. To cancel learning Press RM SET UP. Also, not pressing any button for 60 seconds cancels the settings. 128US