Sony STR-K7100 Service Manual - Page 13
Str-k7100, Fm Tuner Check - receiver
View all Sony STR-K7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
1. DCAC DSP Data Line Checking After press the [TUNING MODE], DCAC Factory test mode will start, below display will show: "DCAC[][][]x" x=1, 2, 3 If there is error happen, below display will show: "ERR[]SD0x" x=1 t D1501 or R1530 problem x=2 t D1502 problem x=3 t D1503 problem 2. DCAC board Checking Connect front left speaker of the receiver and AUTO CAL microphone. Turn [MASTER VOLUME] jog, there will be test tone sound output from front left speaker, and the display will change accordingly. "AD[]-[]xxx" xxx=0 to 255 (depends on loudness of test tone) STR-K7100 SECTION 4 FM TUNER CHECK FM AUTO STOP CHECK (1) Turn on the set. (2) Input the following signal from Signal Generator to FM antenna input directly. * Carrier Frequency: A=87.5 MHz, B=98 MHz, C=108 MHz Deviation : 75 kHz Modulation : 1 kHz ANT input : 35 dBu (EMF) (Note) Please use 75 ohm "coaxial cable" to connect SG and the set. You cannot use video cable for checking. Please use SG whose output impedance is 75 ohm. (3) Set to FM tuner function and scan the input FM signal with automatic scanning. (4) Confirm that input Frequency of A, B and C are detected and automatic scanning stops. The stop of automatic scanning means "The station signal is received in good condition." 13