Sony SVR-2000 Setup Guide - Page 53

Note • You can program the following keys with the Learning Remote method: TV POWER, VOL (volume) +/-, and MUTING. • Do not attempt this method if there is bright fluorescent lighting or other IR interference. • Unlike code entry and code search, you need to program each button individually in learning mode. • If you have a stereo system connected to the SVR Recorder, you can program the POWER button on the Remote Control to turn on/off your stereo. To do so, use code 1975 instead of 0975 in step 1. You can program the POWER button to turn on/off both your TV and your stereo. • To reset the Remote Control back to the manufacturer's settings, press and hold the TiVo and TV POWER buttons together for three seconds until the LED on the Remote Control remains lit. Enter code 0981 (or 1981) using the number keys on the Remote Control. Learning Mode Method The Remote Control has the ability to "learn" codes from your TV (and/or audio system) remote. This method works for every remote controlled TV (or stereo). 1 Put the Remote Control in learning mode. a) Press the TiVo button and TV POWER simultaneously for 3 seconds until the LED on the Remote Control remains lit continuously. b) Using the number keys on the Remote Control, enter the code 0975. The Remote Control LED flashes three times. You have 30 seconds to complete the next step. 2 Position the two remotes. Position the TV remote and the Remote Control head-to-head about two inches apart with their IR emitters facing each other. (The Remote Control's IR emitter is at the end that you point at the TV.) 3 Send the signal to the Remote Control. a) Press the button on the Remote Control that you want to teach. For example, TV POWER or MUTING. The Remote Control LED will flash rapidly to indicate that it is ready to be taught. You have 4 seconds to do the next step. b) Press the equivalent button on the TV remote. For example, if you pressed TV POWER on the Remote Control, press the power button on the TV remote. c) Press and hold the equivalent button on the TV remote until the Remote Control's LED flashes three times to indicate that it has learned the code, or repeat this step until the LED does flash three times. d) This step can be repeated as many times as needed. 4 Exit learning mode and test the code. a) Press the CLEAR button on the Remote Control to exit learning mode. b) Point the Remote Control at the TV and press the button you just taught. For example, if you've just taught the TV POWER button, it should turn on the TV. Programming Your Remote Control 53 Setting Up Your System