Sony SVR-2000 Setup Guide - Page 54
Code Search Method
UPC - 027242566026
View all Sony SVR-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Note • In this method, when you find the correct code, it will automatically program the TV POWER, VOL +/-, and MUTING buttons on the Remote Control. • If you have a stereo system connected to the SVR Recorder, you can program the POWER button on the Remote Control to turn on and off both the stereo and your TV. To do so, use code 1999 instead of 0999 in step 1. • To reset the Remote Control back to the manufacturer's settings, press and hold the TiVo and TV POWER buttons together for three seconds until the LED on the Remote Control remains lit. Enter code 0981 (or 1981) using the number keys on the Remote Control. Code Search Method Another method of programming the Remote Control to operate your TV and/or stereo system is the code search method. The Remote Control has hundreds of available codes. The correct code for your TV might be available, yet not listed on the screen for your TV brand. 1 Put the Remote Control in code search mode. a) Press the TiVo button and TV POWER simultaneously for three seconds until the LED on the Remote Control remains lit continuously. b) Release the buttons and the LED remains illuminated. c) Using the number keys on the Remote Control, enter the code 0999. 2 Test the code. a) Point the Remote Control at the TV, press TV POWER and see if the TV turns off or on. b) If the TV does turn off or on, confirm that MUTE and VOL (volume) +/- also operate the TV. If they do, go to step 4 below. If they do not, continue with step 3. 3 Try another code. Continue to cycle through each code by pressing CH+, then test the code by repeating step 2 above. Remember, there are hundreds of codes. If the LED goes out. you have reached the end of the codes. 4 Program the Remote Control with the correct code. a) When the code allows the Remote Control to operate the TV power, volume and muting, press ENTER to set the code and exit Code Search mode. b) You can also press CLEAR to exit Code Search mode without setting a new code. 54 Programming Your Remote Control