Sony TAV-L1 Operating Instructions - Page 24

Enjoying the Connected Equipment Programming the remote control POWER FUNCTION buttons Number buttons ENT The remote control is preset to operate Sony brand equipment. Sony Equipment Cable Programmable Code Number 101 (DVR) Satellite receiver 201 (DSS) Follow the steps below to program your system's remote control to operate the other equipment. Find the three-digit code for your equipment from the "Manufacturer's Codes" listed on page 25. If more than one code number is listed, try entering from the code listed first. 1 Press and hold the CABLE or SAT (FUNCTION) you want to program and press POWER simultaneously. The selected FUNCTION button (CABLE or SAT) will flash. 2 Enter the three-digit manufacturer's code number using the number buttons while the button is lit, approximately 30 seconds. 3 Press ENT. When the programming is correct, the selected FUNCTION button will flash twice slowly, and when not, flashes five times quickly. To check if the code works Aim your system's remote control at the equipment, and press POWER. If the equipment responds, the programming is completed. If not, try the next code listed. Notes • If no code is input within the above specified time, or an invalid or incorrect code number is input, the remote control automatically goes back to the previous setting. • In some cases, you may not be able to program your remote control to operate other equipment. In such cases, use the equipment's own remote control. • Dead batteries or removing the batteries may cause the programmable codes to be lost and revert back to factory settings. Reprogramming the codes may be necessary. 24 US