Sony VPL FX40 Operating Instructions - Page 38

Setting items Functions Initial setting ID Mode Assigns an ID number (1 to 3) to the projector when you All want control two or more projectors individually with the supplied Remote Commander. When this item is set to "1," you can control the projector with the Remote Commander with the ID MODE key set to "1." When it is set to "All," you can control all the projectors with the Remote Commander independently of the ID MODE keys of the Remote Commander. Illumination Selects whether the SONY logo on the top panel of the On projector lights when the projector is on. Direct Power On Set to "On" if you are using a circuit breaker to turn the Off power on/off the entire system. You can turn the power on/ off without pressing the power key on the projector. Blanking Adjust the displayable area within the four directions of the 0 screen. Select each screen edge "left / right / up / bottom" on the Blanking adjustment screen with M / m key. Adjust the desired Blanking value with < / , key. Notes • Since the V keystone function is an electronic correction, sometimes the image will be deteriorated. • Depending on the picture position adjusted with the lens shift feature, the aspect ratio of the picture may change from the original or picture distortion may occur with V Keystone adjustment. • When both Blanking and V Keystone are adjusted at the same time, Blanking may not function properly. When you use Blanking, set the V Keystone to "0." • Since the displayable area becomes narrower when Blanking value is adjusted, information necessary on Input-E may not be displayed. 38 The Installation Menu