Sony VPL-PS10 Operating Instructions - Page 39
Troubleshooting, Image, Power, Sound
View all Sony VPL-PS10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Troubleshooting Troubleshooting If the projector appears to be operating erratically, try to diagnose and correct the problem, using the following guide. If the problem still persists, consult with qualified Sony personnel. Power Symptom The power is not turned on. Cause Remedy The power has been turned off and on Wait for about 90 seconds before turning on the with the I / 1 key at too short an interval. power (see page 25 (GB)). The lamp cover is detached. Close the lamp cover securely (see page 37 (GB)). The air filter cover is detached. Close the air filter cover securely (see page 38 (GB)). Image Symptom Cause Remedy No picture. A cable is disconnected or not connected Check that the proper connections have been properly. made (see pages 18 (GB) to 23 (GB)). The input selection is incorrect. Select the input source correctly using the INPUT key (see page 24 (GB)). The picture is cut off. Press the PIC MUTING key on the VPL-PX15/ PX10 Remote Commander to release the muting function (see page 14 (GB)). The computer signal is not set to output Set the computer signal to output to an external to an external monitor. monitor (see page 18 (GB)). The picture is noisy. The computer signal is set to output to Set the computer signal to output only to an both the LCD of the computer and an external monitor (see page 18 (GB)). external monitor. Noise may appear on the background Change the desktop pattern on the connected depending on the combination of the computer. numbers of dot input from the connector and numbers of pixels on the LCD panel. On-screen display does not STATUS in the SET SETTING menu has Set STATUS in the SET SETTING menu to ON appear. been set to OFF. (see page 32 (GB)). The picture from INPUT B is There is something wrong with the frozen. (VPL-PX15 only) network software. Set INPUT-B FUNC. in the INSTALL SETTING menu to OFF, then set it to ON again (see page 33 (GB)). The color balance of the video The color system of the input signal is picture is not correct. not set correctly. Set COLOR SYS in the PICTURE CTRL menu to match the color system of the input signal (see page 29 (GB)). Sound Symptom Cause Remedy No Sound. A cable is disconnected or not connected Check that the proper connections have been properly. made (see pages 18 (GB) to 23 (GB)). The sound is cut off. Press the AUDIO MUTING key on the VPL-PX15/ PX10 Remote Commander to release the muting function (see page 14 (GB)). When inputting sound through Monaural sound is being input through the AUDIO jack, sound comes the AUDIO jack. through one channel only. Input stereo sound. 39 (GB)