Sony VPL-PS10 Operating Instructions - Page 40

Troubleshooting Others Symptom The LAMP/COVER indicator flashes. Cause The lamp cover or the air filter cover is detached. The LAMP/COVER indicator lights up. The lamp has reached the end of its life. The lamp has reached too a high temperature. The TEMP/FAN indicator flashes. The TEMP/FAN indicator lights up. The fan is broken. The internal temperature is unusually high. Both LAMP/COVER and The electrical system has failed. TEMP/FAN indicators light up. The INPUT B window does not appear, or INPUT B cannot be selected. (VPLPX15 only) INPUT-B FUNC. is set to OFF. The menu display does not appear even when you press the MENU key on the VPLPX15/PX10 Remote Commander. The PJ/NETWORK select switch on the Remote Commander is set to NETWORK. Remedy Attach the cover securely (see pages 37 (GB) and 38 (GB)). Replace the lamp (see page 37 (GB)). Wait for 90 seconds to cool down the lamp and turn on the power again (see page 25 (GB)). Consult with qualified Sony personnel. Check to see if nothing is blocking the ventilation holes. Consult with qualified Sony personnel. Set INPUT-B FUNC. in the INSTALL SETTING menu to ON (see page 33 (GB)). Set the PJ/NETWORK select switch to PJ, then press the MENU key. Warning messages Use the list below to check the meaning of the messages displayed on the screen. Message High temp.! Lamp off in 1 min. Frequency is out of range! Please check INPUT-A setting. Please replace the LAMP. Backup Battery Very Low (VPL-PX15 only) Meaning Remedy Internal temperature is too high. This input signal cannot be projected as the frequency is out of the acceptable range of the projector. The resolution setting of the output signal of the computer is too high. Turn off the power. Check to see if something is blocking the ventilation holes. Input a signal that is within the frequency range. Set the setting of output to XGA (VPL-PX15/PX10) or SVGA (VPL-PS10) (see page 18 (GB)). You have input an RGB signal from the computer when INPUT-A in the SET SETTING menu is set to COMPONENT or VIDEO GBR. It is time to replace the lamp. The backup battery for the network is exhausted. Set INPUT-A correctly (see page 32 (GB)). Replace the lamp. Consult with qualified Sony personnel. Caution messages Use the list below to check the meaning of the messages displayed on the screen. Message NO INPUT Not applicable! Meaning No input signal You have pressed the wrong key. Remedy Check connections (see pages 18 (GB) to 23 (GB)). Press the appropriate key. 40 (GB)