Stihl FC MM Instruction Manual - Page 12

English Approved MultiEngines Mounting the MultiTool 1 Only use MultiEngines supplied by STIHL or expressly approved by STIHL Removing Existing MultiTools for use with the MultiTool. This MultiTool may only be used in combination with the STIHL MM 56 MultiEngine. WARNING Wear gloves to reduce the risk of injury from contact with sharp MultiTools and/or hot surface of gearbox. 481BA006 KN 481BA008 KN N Use the gunning sight (1) to line up the blade on the edge. Cleaning the blade Pieces of grass or roots may become tightly wrapped around blade mounting during operation. Clean the blade as follows: - Shut off the engine. - Wear work gloves. - Pull the hitch pins out of the axle. - Pull the blade off the axle. - Remove pieces of roots, plants and soil. Refer to "Mounting the MultiTool" for mounting instructions. 10 N Remove the hitch pins and pull the MultiTools (if fitted) off the axle - see also "Mounting the MultiTool" in the instruction manual of the other MultiTool. N Clean the gearbox if necessary. Checking Position of Gearbox WARNING To reduce risk of injury from the MultiTool rotating in the wrong direction, check that position of gearbox is correct and adjust if necessary. FC-MM