Stihl FC MM Instruction Manual - Page 13

English 2 1 3 The axle (1) must be below the shaft (2). Direction of rotation (3) of MultiTool. Adjusting Position of Gearbox 469BA043 KN NOTICE It must not be possible to rotate the gearbox on the drive tube. Mounting the MultiTool The direction of rotation is marked with arrows on the gearbox and cutting blade. Make sure the arrows point in the same direction. 8 4 5 86 4 7 Starting / Stopping the Engine Starting the Engine Always follow the starting procedure described in the MultiEngine instruction manual. 469BA061 AS 481BA007 KN 481BA011 KN 469BA062 AS N Loosen clamp screws on gearbox. N Turn the gearbox through 180°. N Line up the gearbox in the correct position. N Tighten down the two clamp screws on the gearbox in the following sequence: - Tighten the first screw moderately. - Tighten the second screw moderately. - Tighten down first screw firmly. - Tighten down second screw firmly. N Fit the two sleeves (4) on the right and left. N Rotate the blade (5) on the righthand axle (viewed from engine) until it can be pushed into position - check the direction of rotation again (arrows). N Push the wheel (6) and washer (7) onto the left-hand axle (viewed from engine). N Insert and engage both hitch pins (8) in the holes in the axles - fold the hitch pins flat against the blade and wheel. N Secure the handlebar in the normal operating position. N Retract the wheels, if fitted - see chapter on "Wheels" in MultiEngine instruction manual. N Retract the spur, if fitted. FC-MM 11