Stihl FS 55 R Product Instruction Manual - Page 37
Rewind Starter, Lubricating the Gearbox, Storing the Machine - fs 55 repair
View all Stihl FS 55 R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Rewind Starter Lubricating the Gearbox English Storing the Machine To help prolong the wear life of the starter rope, observe the following points: N Pull the starter rope only in the direction specified. N Do not pull the rope over the edge of the guide bushing. N Do not pull out the rope more than specified. N Do not allow the starter grip to snap back, guide it back into the housing slowly - see chapter on "Starting / Stopping the Engine." Have a damaged starter rope replaced by your dealer before it breaks completely. STIHL recommends that you have servicing and repair work carried out exclusively by an authorized STIHL servicing dealer. 1 2 N Check lubricant filling periodically and after approx. every 25 hours of operation N Unscrew the locking screw (1) - if no grease can be seen on the inside, then screw in the tube (2) of STIHL gear lubricant for brushcutters (special accessory) N Squeeze up to 1/5 oz (5 g) of grease into the gear housing Do not completely fill the gear housing with grease. N Unscrew lubricant tube (2) N Refit locking screw and tighten securely 233BA010 KN For periods of 3 months or longer N Drain and clean the fuel tank in a well ventilated area. N Dispose of fuel properly in accordance with local environmental requirements. N Run the engine until the carburetor is dry - this helps prevent the carburetor diaphragms sticking together. N Remove, clean and inspect the cutting attachment. N Thoroughly clean the machine - pay special attention to the cylinder fins and air filter. N Store the machine in a dry and secure location - out of the reach of children and other unauthorized persons. FS 55, FS 55 C, FS 55 R, FS 55 RC 35