Stihl NG 7 Bench Chain Breaker and Rivet Spinner Instruction Manual - Page 6

588BA011 KN Rivet Spinning English Non-approved combinations of cutters and/or chain links can increase the kickback tendency of the chain and expose the user to injury. Wear protective gloves when working with the saw chain to protect your hands from the sharp cutters. : Select spinning head and thrust screw to suit the chain pitch STIHL Oilomatic chain 1/4" Rapid, 3/8" Picco, 0.325" Rapid Spinn- Thrust ing screw head C C 3/8" Rapid , 0.404" Rapid A A, B 1/2", 15 mm Rapid Micro B A, B A : Do not alter the chain link assembly pattern. : Use only identical replacement chain links. 5 5 2 34 6 6 1 588BA008 KN : Screw the thrust screw (1) into the threaded bushing (2) clockwise. : Place spinning head (3) in the holder (4). : Fit the matching chain links on a preset tie strap and place the saw chain over the two guide pulleys (5) - the drive link tangs engage the groove. : Loosen screws (6) and rotate the eccentric guide pulleys until the rivets in the chain links are horizontal and in alignment with spinning head. The preset head of the tie strap must locate in the recessed end of the thrust screw. : Tighten down the screws. 585BA003 KN A, B 588BA007 KN NG 7 15