Sub-Zero 632 Built-In Installation Guide - Page 22

COMPLETING THE INSTALLATION 9 0 D E G R E E DOOR STOP I N S TA L L AT I O N C H E C K L I S T The doors of all Built-In models open to 130 degrees. For Models 601R, 601RG, 601F, 661, 642, 685, 632 and 695, optional 90˚ or 105˚ door stop kits are available through your Sub-Zero dealer. Models 611, 611G, 650 and 650G come with a door stop pin to limit the door swing to 90 degrees. To install the door stop pin for Models 611 and 650, remove the pin from the plastic package located behind the grille and insert it into the space provided on the top hinge plate. Tighten with a screwdriver. Refer to illustration 22 below. For Models 611G and 650G, remove the door stop pin from the plastic package located behind the grille and insert it into the space provided on the lower hinge plate. Tighten with a screwdriver. Refer to illustration 23. The importance of the installation of the Sub-Zero Built-In unit cannot be overemphasized. Proper installation is the responsibility of the selling dealer or installer. IMPORTANT NOTE: To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked. Any questions or problems about the installation should be directed to your Sub-Zero dealer or the Sub-Zero Customer Service Department at 800-222-7820 or e-mail [email protected]. You can also visit our website at subzero.com. Illus. 22 Dimensions in parentheses are in 22 millimeters unless otherwise specified. Illus. 23