Sub-Zero 650 Built-In Use and Care Guide - Page 16

ICE ON/OFF, IMPORTANT NOTE, Models 611, 611G, 650 and 650G, Models 601F, 661, 642 and 632, Models - ice maker filter

Page 16 highlights

S U B - Z E R O B U I LT- I N U S E & C A R E FREEZER STORAGE ICE MAKER OPERATION ICE BUCKET REMOVAL Models 611, 611G, 650 and 650G: To remove the ice bucket, pull the freezer drawer or basket out until it stops and lift the ice bucket out. Models 601F, 661, 642 and 632: To remove the ice bucket, pull it out until it stops, and lift the back of the bucket up to clear the carrier assembly. Next, lift the ice bucket out. If the door is limited to a 90-degree opening, repeat the procedure, but when lifting the ice bucket out, pivot the right side of the bucket toward you and out. This will allow the ice bucket to clear the door. Models 685 and 695: To remove the ice bucket, you must first remove the freezer utility rack. See Freezer Utility Rack, below. Lift up on the ice bucket handle and pull out, supporting the bottom of the ice bucket with one hand. Refer to the illustration below. FREEZER UTILITY RACK Models 685 and 695: The freezer utility rack is specifically designed to accommodate and hold frozen juice containers. To remove the rack, lift up and pull out at the bottom with one hand while you support the top with your other hand. The ice maker in your Sub-Zero freezer is fully automatic and has been tested at the factory. To start making ice, activate the ICE ON/OFF key pad on the Control Center. For Models 601F, 611, 611G, 650, 650G, 661, 642, 685, 632 and 695, the ice maker system will shut off if the ice bucket is not in place. ICE PRODUCTION The ice maker is designed to produce enough ice for normal family use. The timing of icemaking cycles will vary depending on load conditions, door openings and room temperature. On average, you can expect a cycle of ice (eight cubes per cycle) every two hours. The ice maker operates on water pressure of 20 to 100 psi. In some cases, a reverse osmosis water filter system may not be able to maintain the minimum pressure. IMPORTANT NOTE: If ice is not used regularly it tends to fuse together. To avoid this, empty and replace the ice in the container as needed. Ice bucket removal - Models 685 and 695 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

16
ICE MAKER
OPERATION
The ice maker in your Sub-Zero freezer is fully
automatic and has been tested at the factory.
To start making ice, activate the
ICE ON/OFF
key pad on the Control Center.
For Models 601F, 611, 611G, 650, 650G, 661,
642, 685, 632 and 695, the ice maker system
will shut off if the ice bucket is not in place.
ICE PRODUCTION
The ice maker is designed to produce enough
ice for normal family use. The timing of ice-
making cycles will vary depending on load
conditions, door openings and room tempera-
ture. On average, you can expect a cycle of ice
(eight cubes per cycle) every two hours.
The ice maker operates on water pressure of
20 to 100 psi. In some cases, a reverse
osmosis water filter system may not be able to
maintain the minimum pressure.
IMPORTANT NOTE:
If ice is not used regularly
it tends to fuse together. To avoid this, empty
and replace the ice in the container as needed.
FREEZER
STORAGE
ICE BUCKET REMOVAL
Models 611, 611G, 650 and 650G:
To remove
the ice bucket, pull the freezer drawer or basket
out until it stops and lift the ice bucket out.
Models 601F, 661, 642 and 632:
To remove
the ice bucket, pull it out until it stops, and lift
the back of the bucket up to clear the carrier
assembly. Next, lift the ice bucket out. If the
door is limited to a 90-degree opening, repeat
the procedure, but when lifting the ice bucket
out, pivot the right side of the bucket toward
you and out. This will allow the ice bucket to
clear the door.
Models 685 and 695:
To remove the ice
bucket, you must first remove the freezer utility
rack. See Freezer Utility Rack, below. Lift up on
the ice bucket handle and pull out, supporting
the bottom of the ice bucket with one hand.
Refer to the illustration below.
FREEZER UTILITY RACK
Models 685 and 695:
The freezer utility rack is
specifically designed to accommodate and hold
frozen juice containers. To remove the rack, lift
up and pull out at the bottom with one hand
while you support the top with your other
hand.
SUB-ZERO
BUILT-IN
USE & CARE
Ice bucket removal –
Models 685 and 695