Sub-Zero 685 Built-In Installation Guide - Page 20

COMPLETING THE INSTALLATION S I D E PA N E L I N S TA L L AT I O N If you're installing a Built-In model with side panels, check with your installer or use one of the following Side Panel Installation Options. Drill three holes equidistant in a vertical section of the aluminum frame, and install pan head screws. Do not drill through model and serial number plate. Anchor the side panel with decorative screws or finishing nails from a local hardware store. Do not use adhesives. Refer to illustration 16 below. SIDE PANEL INSTALLATION OPTIONS 1/4" (6) THICK SIDE PANEL FITTED IN TO UNIT FRAME DOOR PAN HEAD SCREW 1/8" (3) THICK BATTENS SIDE OF SUB-ZERO UNIT FRAME 1/4" (6) SIDE PANEL MATERIAL 241/4" (616) W The dimensions given in the Side Panel Installation Options are for typical wood side panels. If a 1/4" (6) thick or less panel is used and inserted into the return channel extrusion, then a 241/4" (616) wide panel is necessary. In this application, the panel must be notched for the grille and other brackets or screws that are in the return channel. Toe kick cut-outs will be necessary for all side panel applications. Refer to illustration 17 below. IMPORTANT NOTE: The use of side panels may change the width of your rough opening. IMPORTANT NOTE: The overall height on the side panel will vary with the height of the grille being used. Make sure you know your finished height before cutting any panels. 1/4" (6) THICK SIDE PANEL FITTED UP TO UNIT FRAME DOOR PAN HEAD SCREW 1/8" (3) THICK BACK-UP 1/4" (6) THICK BATTENS SIDE OF SUB-ZERO UNIT FRAME 1/4" (6) SIDE PANEL MATERIAL 24" (610) 3/8" (10) THICK SIDE PANEL FITTED UP TO UNIT FRAME DOOR PAN HEAD SCREW 1/8" (3) THICK BATTENS SIDE OF SUB-ZERO UNIT FRAME 3/8" (10) SIDE PANEL MATERIAL 24" (610) 1/2" (13) THICK SIDE PANEL FITTED UP TO UNIT FRAME DOOR PAN HEAD SCREW FRAME 1/8" (3) ROUT DOOR 11/8" (29) PAN HEAD SCREW FRAME SIDE PANEL Illus. 16 131/4" (337) 1/4" (6) 1/4" (6) 3" (76) SIDE OF SUB-ZERO UNIT 21/2" (64) 1/2" (13) SIDE PANEL MATERIAL 24" (610) METAL SIDE PANEL FITTED UP TO UNIT FRAME DOOR PAN HEAD SCREW SIDE OF SUB-ZERO UNIT FRAME METAL SIDE PANEL MATERIAL 24" (610) Top Views 3" (76) 4" (102) Illus. 17 20 Dimensions in parentheses are in millimeters unless otherwise specified.