Symphonic RSMGD134 Owner's Manual - Page 13
SET UP FOR USE
View all Symphonic RSMGD134 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
SET UP FOR USE TV SECTION SELECTING THE LANGUAGE TV 1 Plug in the TV/DVD power cord Plug the TV/DVD power cord into a standard AC outlet. NOTE: • If any digits appear in the corner of the screen, press POWER without unplugging the power cord. Make sure ... • Press POWER to turn on the TV/DVD. NOTE: This function effects only the language on the screen menu and not the audio source. 2 Select "LANGUAGE" - TV SETUP - Press SETUP on the remote control. CHANNEL SET UP V-CHIP SET UP Press Arrow (K/L) to point to B LANGUAGE [ENGLISH] CAPTION [OFF] "LANGUAGE". CHANNEL SET UP TV You can program the tuner to scan all the channels you receive in your area. NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the TV/DVD channel selector to the output channel of the cable box or satellite box (Ex CH3), then select the channel to be viewed on the Cable Box or Satellite Box. Make sure ... • Press POWER to turn on the TV/DVD. 1 Select "CHANNEL SET UP" Press SETUP on the remote control. - TV SETUP - Press Arrow (K/L) to point to "CHANNEL SET UP". Then press ENTER. B CHANNEL SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF] 3 Select "ENGLISH", "ESPAÑOL" or "FRANÇAIS" Select "ENGLISH", "ESPAÑOL"= Spanish or "FRANÇAIS"= French using ENTER. 4 Exit the Language mode Press SETUP to return to TV mode. NOTE: If for some reason the menu is in Spanish or French, press SETUP, press Arrow (K/L) to point to "IDIOMA [ESPAÑOL]" or "LANGAGE [FRANÇAIS]", then press ENTER, then press SETUP on the remote control. 2 Begin auto ch programming Press Arrow (K/L) to point to "AUTO CH PROGRAMMING". Then press ENTER. The tuner scans and memorizes all the active channels in your area. - CHANNEL SET UP - ADD / DELETE CH (CATV) B AUTO CH PROGRAMMING 3 After scanning The tuner stops on the lowest memorized channel. • When AUTO CH PROGRAMMING is activated where there is no TV signal input, "NO TV SIGNALS" will appear on the display after the completion of the channel scanning. • The TV/DVD may recognize TV channels to be CATV channels by the receiving conditions. In this case, try auto ch programming again in the fine receiving conditions. - 13 - EN 0C28