Symphonic SC309A Owner's Manual - Page 23
appears
View all Symphonic SC309A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
OTR (One Touch Recording) This function enables you to set a recording length simply by pressing the REC/OTR button on the TVNCR. Make sure ... • TVNCR power must be turned on. Push(es) I push 2 pushes 3 pushes 4, 17 pushes Display Recording length (normal recording) 0:30 30 minutes 1:00 60 minutes 4, 4. 8:00 480 minutes • Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or fast forward the tape to the point at which you want to begin COPYING A VIDEO CASSETTE (Re wires a VCR or camcorder) recording.) NOTES: • This function CANNOT be done from the remote control. • Recording starts immediately when the REC/OTR button is pressed. You can make copies of video tapes made by friends or relatives for your enjoyment. WARNING: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws. • When the REC/OTR button is pressed 18 times, the Connect your TV/VCR and a Source (Playing) VCR TVNCR returns to the Normal Recording mode. using the following diagram. • To stop the OTR operation, press the STOP button on the TV/VCR or on the remote control. [Fig.9] • To show the remaining time, press the DISPLAY button on the remote control so that "OTR" appears on the TV screen. (It will show up momen- AUDIO , IDEO [The TVNCR] tarily then disappear.) • Recording stops when 0:00 is reached. • Please note that in the SLP mode maximum record- ing time, assuming the tape is started at the beginning, is 8 hours using T-160 (or 6 hours using T-120). • If the tape runs out before the end time, the [Ex: Source (playing) VCR or camcorder] TVNCR will switch to the Stop mode immediate- ly, ejects the tape and turns itself off. VIDEO AudioNideo 1 Select the channel to be recorded adapter cable 3 AUDIO6 Press the number buttons on the remote control or the (not supplied) CHANNEL A or button. Remember: If the TVNCR is connected to a cable box or satellite box, the TV/VCR must be on CH3 or CH4, then the channel to be recorded is selected on the cable box or satellite box. 1)Insert a pre-recorded video cassette into the Source (Playing) VCR or camcorder. 2)Insert a blank video cassette, or one you want to record over, into the TV/VCR's cassette compartment. 2 Select the tape speed Press the SPEED button to select the desired tape speed (SP/ SLP). 3)Press the SPEED button on remote control for the TVNCR to select the desired recording speed (SP/SLP). 4)Press the CHANNEL A or V button on the TVNCR until "AUX" appears on the screen. 3 Begin OTR OTRR 30) 5)Press the RECORD button on the TVNCR. Press the REC/OTR button on the 6)Begin playback of the tape in the source (Playing) TVNCR as many times as needed. VCR or camcorder. The recording length will be deter- NOTE: For best results during dubbing, use the mined by the number of times you TV/VCR's front panel controls whenever possible. press the REC/OTR button. Each additional push will The remote control might affect the source (Playing) increase the recording time by 30 minutes. It is set up VCR's playback operation. to 8 hours. - 23 - EN 9J27