TASCAM DM-24 Installation and Use Effects Manual - Page 6

1 - Internal Effects on the DM-24-Effect send sources on the OUT section of the screen when the loop assignment is made and is shown as Chxx (xx = 1 through 32). If no channel has been assigned, the display shows ---. If more than one channel has been assigned as a return, the display shows ****. Aux 1 through Aux 6 insert When these are selected as effect input sources (AUXx INS SEND), the effect becomes an insert-type effect. This insert is made post aux send fader. The outputs of the effect are automatically assigned to the appropriate aux insert returns and shown as AUX INS RETURN. Buss 1 through buss 8 insert When these are selected as effect input sources (BUSSx INS SEND), the effect becomes an insert-type effect. This insert is made post buss level fader. The outputs of the effect are automatically assigned to the appropriate buss insert returns and shown as BUSS INS RETURN. Stereo L, R insert When these are selected as effect input sources (ST-L PRE SEND and ST-R PRE SEND), the effect becomes an insert-type effect. Effect 1-2 series When the two effects units are selected to act in series, with effect 1 feeding effect 2, although both effect 1 and effect 2 are shown on the screen, only the inputs to effect 1 may be set. The output(s) from effect 1 are automatically routed to the input(s) of effect 2. If the source of effect 1 is an aux send, the effect 2 output is assigned to a channel (set using the I/O screen). This insert is made pre stereo master fader. The outputs are automatically assigned to the stereo insert returns are shown as ST-L PRE RETURN and ST-R PRE RETURN. Assignable inserts 1 through 4 When these are selected as effect input sources (ASGN INSx SEND), the effect becomes an insert-type effect. For these to be effective, the assignable send/returns must be set to be inserts, not send/return loops (see "Assignable sends and returns" on page 43 of the main manual). If they have been set to send/return loops, a popup message appears informing you of the fact. Note that when an assignment is made to these inserts, the corresponding physical 1/4" jacks are no longer available (these settings override the physical jack insert assignments). The outputs from the effects are sent to the assignable insert return. This is shown in the output assignment section of the effect as ASGN INSx RTN CH y if a channel assignment has been made, or ASGN INSx RTN --- if no assignment has been made. If the source of effect 1 is an insert, the output of effect 2 defaults to the insert return as shown in the output assignment section of effect 2. The outputs from effect 1 are shown as EFFECT2 IN L and EFFECT2 IN R, and the inputs to effect 2 are shown as EFFECT1 OUT L and EFFECT1 OUT R (if effect 2 is a dual-channel effect). If channel 2 is set to output only a single channel, the single output from effect 1 is labeled as EFFECT2 IN L and if there is a single input to effect 2, this is labeled EFFECT1 OUT L. 6 TASCAM DM-24 Effects