TEAC AI-501DA AI-501DA Owner's Manual - Page 13

Basic operation, Minimize the volume., Set the POWER switch to ON. - usb driver

Get TEAC AI-501DA PDF manuals and user guides View all TEAC AI-501DA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Basic operation 1 Minimize the volume. Use the VOLUME knob or the remote control VOLUME buttons to minimize the volume. ooIf digital audio signals input through OPT1, OPT2 or COAX inputs are in a format other than PCM (e.g. Dolby Digital, DTS, AAC), the input indicator will EN blink. Since this unit only supports the input of PCM format signals, confirm that the digital output of the connected equipment is in PCM format. Some devices convert signals into PCM format before output. See the operation manuals for the connected devices. ooBefore connecting a computer and selecting USB, install the dedicated driver on the computer (see p. 14). Playback from a computer that does not have this driver installed is not possible. −∞ dB: Minimum volume 0 dB: Maximum volume 2 Set the POWER switch to ON. 4 Operate the playback device. Refer to the operation manual of that device. 5 Adjust the volume. 3 Turn the INPUT SELECTOR knob to select the input source. −∞ dB: Minimum volume 0 dB: Maximum volume Start playback on the source and use the VOLUME knob or remote control VOLUME buttons to adjust the volume to its optimal level. The indicator for the selected source lights. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
13
EN
1
Minimize the volume.
Use the VOLUME knob or the remote control VOLUME
buttons to minimize the volume.
−∞ dB: Minimum volume
0 dB: Maximum volume
2
Set the POWER switch to ON.
3
Turn the INPUT SELECTOR knob to select
the input source.
The indicator for the selected source lights.
Basic operation
o
If digital audio signals input through OPT1, OPT2 or
COAX inputs are in a format other than PCM (e.g.
Dolby Digital, DTS, AAC), the input indicator will
blink. Since this unit only supports the input of PCM
format signals, confirm that the digital output of
the connected equipment is in PCM format. Some
devices convert signals into PCM format before out-
put. See the operation manuals for the connected
devices.
o
Before connecting a computer and selecting USB,
install the dedicated driver on the computer (see p.
14). Playback from a computer that does not have
this driver installed is not possible.
4
Operate the playback device.
Refer to the operation manual of that device.
5
Adjust the volume.
−∞ dB: Minimum volume
0 dB: Maximum volume
Start playback on the source and use the VOLUME
knob or remote control VOLUME buttons to adjust the
volume to its optimal level.