TEAC UD-301 Owner's Mamual (English, Français, Español) - Page 14
Automatic power saving (APS) function, Upconversion function
View all TEAC UD-301 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Automatic power saving (APS) function This unit has an automatic power saving function. So, by default, the unit will enter automatic power saving mode automatically after 30 minutes elapse without any locked input signal. (Power consumption in this standby mode is 0.5 W or less.) oo The automatic power saving function is on when the unit is shipped from the factory. Checking the automatic power saving setting If automatic power saving is off, all the input indicators will light temporarily when the unit is turned on. Setting the automatic power saving function When the unit is on, press and hold the ¤ button for five seconds until all the input indicators light or turn off. No indicators lit: APS on All indicators lit: APS off Press and hold Upconversion function When using a digital input (USB*, OPTICAL or COAXIAL), the upconversion function can be used. *DSD audio will not be upconverted. Press and hold the source button for about five seconds until the sampling frequency indicators light as follows. 44.1kHz and 48kHz indicators lit: Upconversion off 44.1kHz to 96kHz indicators lit: Upconversion setting 1 44.1kHz to192kHz indicators lit: Upconversion setting 2 Input frequency and frequency after upconversion Input frequency 44.1 kHz 48 kHz 88.2 kHz 96 kHz Setting 1 88.2 kHz 96 kHz No upconversion No upconversion Setting 2 176.4 kHz 192 kHz 176.4 kHz 192 kHz oo Frequencies of 176.4 kHz and higher will not be upconverted when input. Sampling frequency indicators during upconversion When upconversion is in use, two sampling frequency indicators will light. The left one shows the input frequency and the right one shows the frequency after upconversion. Press and hold 14