TP-Link CPE220 CPE520 V1.1 Installation Guide - Page 13

Configuration for Typical Applications

Get TP-Link CPE220 PDF manuals and user guides View all TP-Link CPE220 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

2. Configuration for Typical Applications The typical topology is as follows. A wireless bridge is built between two locations that are far from each other. Follow the instructions below to configure the Access Point and the Client. Computer IP camera Access Point LAN: 192.168.0.254 Client LAN: 192.168.0.2 Configure the Access Point (AP) 1. Log in to PharOS and go to the Quick Setup page. 2. Operation Mode: Select Access Point and click Next. 3. LAN Settings: Click Next. 4. Wireless AP Settings: a. Create a new SSID (Network name) for your wireless network. b. Select WPA-PSK/WPA2-PSK for the Security method and create a PSK Password to protect your AP. c. Enter the distance between the Access Point and the Client into the Distance Setting field. d. Select the MAXtream checkbox (Refer to Q3 in FAQ for details about MAXtream), and click Next. 5. Finish: Verify your settings and click Finish to complete the configuration. Configure the Client 1. Log in to PharOS and go to the Quick Setup page. 2. Operation Mode: Select Client and click Next. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
10
2. Configuration for Typical Applications
The typical topology is as follows. A wireless bridge is built between two
locations that are far from each other. Follow the instructions below to
configure the Access Point and the Client.
Access Point
Client
Computer
IP camera
LAN: 192.168.0.254
LAN: 192.168.0.2
Configure the Access Point (AP)
1.
Log in to PharOS and go to the Quick Setup page.
2.
Operation Mode: Select
Access Point
and click
Next
.
3.
LAN Settings: Click
Next
.
4.
Wireless AP Settings:
a.
Create a new SSID (Network name) for your wireless network.
b.
Select
WPA-PSK/WPA2-PSK
for the Security method and create a
PSK Password to protect your AP.
c.
Enter the distance between the Access Point and the Client into
the Distance Setting field.
d.
Select the
MAXtream
checkbox (Refer to Q3 in FAQ for details
about MAXtream), and click
Next
.
5.
Finish: Verify your settings and click
Finish
to complete the
configuration.
Configure the Client
1.
Log in to PharOS and go to the Quick Setup page.
2.
Operation Mode: Select
Client
and click
Next
.