Home » TP-Link Manuals » Hubs & Switches » TP-Link T1600G-28TSTL-SG2424 » Manual Viewer

TP-Link T1600G-28TSTL-SG2424 T1600G-28TS V1 User Guide - Page 171

Global Config, 3.3 Port Config

View all TP-Link T1600G-28TSTL-SG2424 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 171 highlights

3. When egress rate limit feature is enabled for one or more ports, you are suggested to disable the flow control on each port to ensure the switch works normally. 10.3.2 Global Config On this page, you can configure the global parameters of the voice VLAN, including VLAN ID and aging time. Choose the menu QoS→Voice VLAN→Global Config to load the following page. Figure 10-12 Global Configuration The following entries are displayed on this screen:  Global Config Voice VLAN: Select Enable/Disable Voice VLAN function. VLAN ID: Enter the VLAN ID of the voice VLAN. Aging Time: Specifies the living time of the member port in auto mode after the OUI address is aging out. Priority: Select the priority of the port when sending voice data. 10.3.3 Port Config Before the voice VLAN function is enabled, the parameters of the ports in the voice VLAN should be configured on this page. Choose the menu QoS→Voice VLAN→Port Config to load the following page. 162

Section	Page
Package Contents	10
Chapter 1 About this Guide	11
1.1 Intended Readers	11
1.2 Conventions	11
1.3 Overview of This Guide	11
Chapter 2 Introduction	15
2.1 Overview of the Switch	15
2.2 Appearance Description	15
2.2.1 Front Panel	15
2.2.2 Rear Panel	20
Chapter 3 Login to the Switch	22
3.1 Login	22
3.2 Configuration	23
Chapter 4 System	24
4.1 System Info	24
4.1.1 System Summary	24
4.1.2 Device Description	25
4.1.3 System Time	26
4.1.4 Daylight Saving Time	27
4.1.5 System IPv6	28
4.2 User Management	37
4.2.1 User Table	37
4.2.2 User Config	37
4.3 System Tools	38
4.3.1 Boot Config	39
4.3.2 Config Restore	40
4.3.3 Config Backup	40
4.3.4 Firmware Upgrade	41
4.3.5 System Reboot	42
4.3.6 System Reset	42
4.4 Access Security	43
4.4.1 Access Control	43
4.4.2 HTTP Config	44
4.4.3 HTTPS Config	45
4.4.4 SSH Config	47
4.4.5 Telnet Config	54
Chapter 5 Switching	55
5.1 Port	55
5.1.1 Port Config	55
5.1.2 Port Mirror	56
5.1.3 Port Security	58
5.1.4 Port Isolation	60
5.1.5 Loopback Detection	61
5.2 LAG	63
5.2.1 LAG Table	64
5.2.2 Static LAG	65
5.2.3 LACP Config	66
5.3 Traffic Monitor	68
5.3.1 Traffic Summary	68
5.3.2 Traffic Statistics	69
5.4 MAC Address	71
5.4.1 Address Table	72
5.4.2 Static Address	73
5.4.3 Dynamic Address	74
5.4.4 Filtering Address	76
Chapter 6 VLAN	78
6.1 802.1Q VLAN	79
6.1.1 VLAN Config	80
6.1.2 Port Config	81
6.2 Application Example for 802.1Q VLAN	83
6.3 MAC VLAN	84
6.3.1 MAC VLAN	85
6.3.2 Port Enable	85
6.4 Application Example for MAC VLAN	86
6.5 Protocol VLAN	88
6.5.1 Protocol Group Table	89
6.5.2 Protocol Group	89
6.5.3 Protocol Template	90
6.6 Application Example for Protocol VLAN	92
Chapter 7 Spanning Tree	94
7.1 STP Config	99
7.1.1 STP Config	99
7.1.2 STP Summary	101
7.2 Port Config	102
7.3 MSTP Instance	103
7.3.1 Region Config	104
7.3.2 Instance Config	104
7.3.3 Instance Port Config	105
7.4 STP Security	107
7.4.1 Port Protect	107
7.4.2 TC Protect	110
7.5 Application Example for STP Function	110
Chapter 8 Multicast	115
8.1 IGMP Snooping	119
8.1.1 Snooping Config	121
8.1.2 Port Config	123
8.1.3 VLAN Config	124
8.1.4 Multicast VLAN	125
8.1.5 Querier Config	128
8.1.6 Profile Config	130
8.1.7 Profile Binding	131
8.1.8 Packet Statistics	133
8.2 MLD Snooping	134
8.2.1 Snooping Config	136
8.2.2 Port Config	137
8.2.3 VLAN Config	138
8.2.4 Multicast VLAN	139
8.2.5 Querier Config	141
8.2.6 Profile Config	142
8.2.7 Profile Binding	144
8.2.8 Packet Statistics	146
8.3 Multicast Table	147
8.3.1 IPv4 Multicast Table	147
8.3.2 Static IPv4 Multicast Table	148
8.3.3 IPv6 Multicast Table	149
8.3.4 Static IPv6 Multicast Table	150
Chapter 9 Routing	152
9.1 Interface	152
9.2 Routing Table	155
9.3 Static Routing	156
9.4 ARP	157
9.4.1 ARP Table	157
9.4.2 Static ARP	157
Chapter 10 QoS	158
10.1 DiffServ	161
10.1.1 Port Priority	161
10.1.2 Schedule Mode	162
10.1.3 802.1P Priority	163
10.1.4 DSCP Priority	164
10.2 Bandwidth Control	166
10.2.1 Storm Control	166
10.3 Voice VLAN	167
10.3.1 Rate Limit	169
10.3.2 Global Config	171
10.3.3 Port Config	171
10.3.4 OUI Config	173
Chapter 11 PoE	175
11.1 PoE Config	175
11.1.1 PoE Config	176
11.1.2 PoE Profile	177
11.2 Time-Range	178
11.2.1 Time-Range Summary	178
11.2.2 Time-Range Create	179
11.2.3 Holiday Config	181
Chapter 12 ACL	182
12.1 ACL Config	182
12.1.1 ACL Summary	182
12.1.2 ACL Create	182
12.1.3 MAC ACL	183
12.1.4 Standard-IP ACL	184
12.1.5 Extend-IP ACL	185
12.2 Policy Config	186
12.2.1 Policy Summary	186
12.2.2 Policy Create	186
12.2.3 Action Create	187
12.3 ACL Binding	187
12.3.1 Binding Table	188
12.3.2 Port Binding	189
12.3.3 VLAN Binding	190
12.4 Policy Binding	190
12.4.1 Binding Table	191
12.4.2 Port Binding	192
12.4.3 VLAN Binding	193
12.5 Application Example for ACL	193
Chapter 13 Network Security	196
13.1 IP-MAC Binding	196
13.1.1 Binding Table	196
13.1.2 Manual Binding	197
13.1.3 ARP Scanning	199
13.2 DHCP Snooping	200
13.2.1 Global Config	204
13.2.2 Port Config	205
13.3 ARP Inspection	206
13.3.1 ARP Detect	210
13.3.2 ARP Defend	211
13.3.3 ARP Statistics	212
13.4 DoS Defend	213
13.4.1 DoS Defend	215
13.5 802.1X	215
13.5.1 Global Config	219
13.5.2 Port Config	221
13.5.3 RADIUS Config	222
Chapter 14 SNMP	225
14.1 SNMP Config	227
14.1.1 Global Config	227
14.1.2 SNMP View	228
14.1.3 SNMP Group	229
14.1.4 SNMP User	230
14.1.5 SNMP Community	232
14.2 Notification	234
14.3 RMON	236
14.3.1 Statistics	237
14.3.2 History	238
14.3.3 Event	239
14.3.4 Alarm Config	240
Chapter 15 LLDP	242
15.1 Basic Config	246
15.1.1 Global Config	246
15.1.2 Port Config	247
15.2 Device Info	248
15.2.1 Local Info	248
15.2.2 Neighbor Info	249
15.3 Device Statistics	250
15.4 LLDP-MED	251
15.4.1 Global Config	252
15.4.2 Port Config	253
15.4.3 Local Info	255
15.4.4 Neighbor Info	256
Chapter 16 Maintenance	257
16.1 System Monitor	257
16.1.1 CPU Monitor	257
16.1.2 Memory Monitor	258
16.2 Log	258
16.2.1 Log Table	259
16.2.2 Local Log	260
16.2.3 Remote Log	261
16.2.4 Backup Log	261
16.3 Device Diagnostics	262
16.3.1 Cable Test	262
16.4 Network Diagnostics	263
16.4.1 Ping	263
16.4.2 Tracert	264
Appendix A: Specifications	266