TP-Link T2600G-28MPSTL-SG3424P T2600G-28MPSUN V2 CLI Reference Guide Guide - Page 428

Chapter 43 sFlow Commands Note: T2600G-18TS doesn't support this command. sFlow (Sampled Flow) is a technology for accurately monitoring network traffic at high speeds. The sFlow monitoring system consists of an sFlow agent (embedded in a switch or router or in a standalone probe) and a central sFlow collector. The sFlow agent is a virtual entity using sampling technology to capture traffic statistics from the device it is monitoring. The sFlow collector can be a host receiving sFlow datagrams from the sFlow agent. The sFlow function is implemented as follows: the sFlow sampler take samples of traffic statistics and send sFlow datagrams to the sFlow agent for processing. The sFlow agent will forward sFlow datagrams to the sFlow collector for analysis. The analytic results can be displayed on the sFlow collector. 43.1sflow address Description The sflow address command is used to configure the sFlow agent's IP address. To delete the configured address, please use no sflow address command. Syntax sflow address { ipv4-addr } no sflow address { ipv4-addr } Parameter ipv4-addr --The IP address of the sFlow agent. The type of the IP address should be IPv4. For example, you can set the switch's management IP as the IP address of the sFlow agent. Command Mode Global Configuration Mode Privilege Requirement Only Admin and Operator level users have access to these commands. Example Configure the sFlow agent with the IP address as 192.168.0.1: T2600G-28TS(config)#sflow address 192.168.0.1 407