TP-Link T2600G-28MPSTL-SG3424P T2600G-28MPSUN V2 CLI Reference Guide Guide - Page 430

port --The number of the udp port which is selected for the sFlow collector. maxData --Specify the maximum number of data bytes that can be sent in a single sample datagram. The value ranges from 300 to 1400 and the default value is 300 bytes. timeout --Specify the aging time of the sFlow collector, ranging from 0 to 2000000 seconds. When the timeout is set to 0, it means the life cycle of the collector is infinite. Command Mode Global Configuration Mode Privilege Requirement Only Admin and Operator level users have access to these commands. Example Specify the ip of the sFlow collector 1 as 192.168.0.100, the port as 3000: T2600G-28TS(config)# sflow collector collector-ID 1 ip 192.168.0.100 T2600G-28TS(config)# sflow collector collector-ID 1 port 3000 43.4sflow sampler Description The sflow sampler command is used to configure the parameters about the sFlow sampler. Syntax sflow sampler { [ collector-ID value ] | [ ingRate ingress-rate ] [ egRate egress-rate ] | [ maxHeader maxHeader ] } Parameter value -- The ID of the sFlow collector which the sFlow sampler will send sFlow datagrams to. The value ranges from 0 to 4. When the value is zero, it means no collector is selected. ingress-rate --Specify the ingress sampling frequency of the sFlow sampler. When a sample is taken, the value indicates how many packets to skip before the next sample is taken. The value ranges from 1024 to 65535 and the default value is 0 which means no packets will be sampled. egress-rate --Specify the egress sampling frequency of the sFlow sampler. When a sample is taken, the value indicates how many packets to skip before 409