TP-Link T2600G-52TS Jetstream L2 Managed SwitchUN Installation Guide - Page 9

JetStream L2 Managed Switch is on. Pressing the mode switch button, the Speed LED will turn off and the PoE LED will light up. Then the PoE LED will turn off after being on for 60 seconds and the Speed LED will light up again. LED PWR SYS FAN PoE Max (When the PoE LED is on) Speed or PoE (When the Speed LED is on) Speed or PoE (When the PoE LED is on) SFP SFP1, SFP2 Indication On: The switch is powered on. Off: The switch is powered off or power supply is abnormal. Flashing: Power supply is abnormal. Flashing: The switch works properly. On or Off: The switch works improperly. Green: All the fans work properly. Yellow: Not all the fans work properly. Off: The switch works improperly. On: The remaining PoE power is equal to or less than 7W. Flashing: The remaining PoE power is equal to or less than 7W and lasts for more than 2 minutes. Off: The remaining PoE power is larger than 7W. Green On: Running at 1000Mbps, but no activity. Green Flashing: Running at 1000Mbps and is transmitting or receiving data. Yellow On: Running at 10/100Mbps, but no activity. Yellow Flashing: Running at 10/100Mbps and is transmitting or receiving data. Off: No device is linked to the corresponding port. Green On: The port is supplying power normally. Green Flashing: The supply power exceeds the correponding port's maximum power. Yellow On: Overload or short circuit is detected. Yellow Flashing: Power-on self-test failed. Off: Not providing PoE power on the port. Note: SFP1 and SFP2 for T2500G-10MPS, SFP for T2600G-28MPS Green On: A 1000Mbps device is linked to the corresponding port, but no activity. Green Flashing: A 1000Mbps device is linked to the corresponding port and data is being transmitted or received. Yellow On: A 100Mbps device is linked to the corresponding port, but no activity. Yellow Flashing: A 100Mbps device is linked to the corresponding port and is transmitting or receiving data. Off: No device is linked to the corresponding port. Console Port (RJ-45/USB) Designed to connect with a computer for monitoring and configuring the switch. For T2500G-10TS/ T250 0 G -10 MPS/ T26 0 0 G -18T S/ T26 0 0 G -28T S/ T26 0 0 G -28T S - DC/ T26 0 0 G -28 MPS/ T2600G-28SQ/T2600G-52TS, the switch has an RJ-45 console port and a micro-USB console port. Console input is active on only one console port at a time. By default, the micro-USB connector takes precedence over the RJ-45 connector. 10/100Mbps RJ45 Port Designed to connect to the device with a bandwidth of 10Mbps or 100Mbps. Introduction 05