TP-Link TL-ER6020 TL-ER6020 v1 IG 7106503927 - Page 6

Gigabit Dual-WAN VPN Router Interface Description Interface WAN LAN DMZ Console Description The WAN port is designed to connect the Router to the interface provided by ISP via the RJ45 cable The LAN port is designed to connect the Router to the local PCs or switches by the RJ45 cable The DMZ port is designed to connect the Router to the servers The Console port is designed to connect with the serial port of a computer or terminal to check and monitor some simple system information of the Router Reset Use the button to restore the Router to the factory defaults. With the Router powered on, use a pin to press and hold the Reset button (about 4~5 seconds). After the SYS LED goes out, release the Reset button. If the SYS LED is flashing with a high frequency about two or three seconds, it means the Router is restored successfully. ■■ Rear Panel The rear panel of TL-ER6020 is shown as the following figure. FFFFFFFFFFF Rear Panel Power Socket Connect the female connector of the power cord here, and the male connector to the AC power outlet. Please make sure the voltage of the power supply meets the requirement of the input voltage. Grounding Terminal The Router already comes with lightning protection mechanism. You can also ground the Router through the PE (Protecting Earth) cable of AC cord or with Ground Cable. For detailed information, please refer to Chapter 3 Lightning Protection. Kensington Security Slot The Router provides one security slot. Caution: Please use the provided power cord. 02 Introduction