TP-Link TL-SG1008PE Installation Guide - Page 8
Rear Panel
![]() |
View all TP-Link TL-SG1008PE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Gigabit Unmanaged Switch The front panel of TL-SG1008 is shown as the following figure. LEDs 10/100/1000Mbps RJ45 Port FFFFFFFFFFF Front Panel of TL-SG1008 LEDs LED Power Link/Act Status On Off On Flashing Off On 1000Mbps Off Indication The Switch is powered on The Switch is powered off or power supply is abnormal There is a device linked to the corresponding port but not active The corresponding port is transmitting or receiving data There is no device linked to the corresponding port A 1000Mbps device is connected to the corresponding port A 10/100Mbps device or no device is connected to the corresponding port Note: TL-SG1048 has no 1000Mbps LEDs while its Link/Act LEDs can indicate port speed by flashing different colors (Green:1000Mbps, Yellow:10/100Mbps). 10/100/1000Mbps Port Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding Link/Act LED and a 1000Mbps LED. TL-SG1048 has no 1000Mbps LEDs while its Link/Act LEDs can indicate port speed by flashing different colors (Green:1000Mbps,Yellow:10/100Mbps). Rear Panel The rear panel of TL-SG1048 is shown as the following figure. FFFFFFFFFFF Rear Panel of TL-SG1048 Power Socket Grounding Terminal The rear panel of TL-SG1024/TL-SG1016 is shown as the following figure. 03 Introduction
![](/manual_guide/products/tplink-tlsg1008pe-installation-guide-239b45e/8.png)