TP-Link TL-SL2218 TL-SL2218 V1 IG 7106504093 - Page 20

Smart Switch CCCCCCCCCC Connection 4444 Ethernet Port Please connect the Ethernet ports of the switch to the network devices by RJ45 cable as the following figure shown. RJ45 Port RJ45 Cable FFFFFFFFFFF Connecting the RJ45 Port 4444 SFP Port Connect the SFP port to a SFP module. For the switch, if an SFP transceiver (purchased separately) is installed in a slot and has a valid link on the port, the associated RJ45 port will be disabled and cannot be used. SFP Port SFP Module FFFFFFFFFFF Connecting the LAN Port Note: ■■ SFP module supports hot-plugging, plug the SFP module into the SFP port and the switch can identify it automatically. ■■ The SFP port supports 100/1000Base-FX SFP module at full-duplex mode. When using a SFP module, you need to log on to the GUI of the switch and configure the corresponding Speed and Duplex mode on Switching→Port→Port Config page. For 100M module, please select 100MFD while select 1000MFD for gigabit module. By default, the Speed and Duplex mode of SFP mode is 1000MFD. 15 Connection