TRENDnet 12dBi User's Guide - Page 126
Con UPnP, Con SNMP Setup, Disable, Reboot, Network Places
View all TRENDnet 12dBi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
TRENDnet User's Guide Configure UPnP Universal Plug and Play(UPnP) is an architecture to enable pervasive peer-to-peer network connectivity between PCs, intelligent devices and appliances when UPnP is supported. UPnP works on TCP/IP network to enable UPnP devices to connect and access to each other, very well adopted in home networking environment. TEW-676APBO Configure SNMP Setup SNMP is an application-layer protocol that provides a message format for communication between SNMP managers and agents. By enabling SNMP function, the administrator can obtain the system information remotely. Please click on System -> SNMP Setup and follow the below setting. UPnP : By default, it's "Disable". Select "Enable" or "Disable" of UPnP Service. Click Save button to save changes and click Reboot button to activate changes For UPnP to work in Windows XP, the "TEW-676APBO" must be available in "My Network Places", as shown here: (your specific model may vary) SNMP v2c Enable: Check to enable SNMP v2c. TEW-675APBO/TEW676APBO If these devices are not available, you should verify that the correct components and services are loaded in Windows XP. Please refer to Appendix E. Using UPnP on Windows XP ro community : Set a community string to authorize read-only access. rw community : Set a community string to authorize read/write access. SNMP v3 Enable: Check to enable SNMP v3. SNMPv3 supports the highest level SNMP security. © Copyright 2012TRENDnet. All Rights Reserved. 126