TRENDnet N300 Quick Installation Guide - Page 4

2. Hardware Installation Note: 1: Wi-Fi Protected Setup (WPS) allows you to quickly connect to your wireless router or access point. If you would like to use WPS push button setup, please go directly to section 4. Wi-Fi Protected Setup (WPS) Push Button Setup. If your wireless router or access point does not support WPS, continue on to section 2 in the Hardware Installation. 2: Do not connect/install the TEW-640MB to your network until instructed to do so. 1. Connect one end of the provided RJ-45 network cable to one of the TEW-640MB's LAN ports. Connect the other end of the cable to your computer's network port. 2. Connect the Power Adapter to the TEW-640MB and then to a power outlet. EU Versions will have a power button on the back. Push the power button to the "On" position (EU Version). Wait 30 seconds for the TEW-640MB to boot up. 3. Verify that the following panel lights are on: Wireless (Blue/Blinking) Network Port (1-4) (Blue/Blinking) Power (Blue/Solid) 2