Thermador CIT304TM Instructions for Use - Page 14

Once the cook time has elapsed The element turnes off once the set cook time has elapsed. You will hear a beep. The indicator ‹ appears in the element display and the timer display shows ‹‹ for 10 seconds. The x indicator in the element display stays on. Touch the TIMER key, to turn the indicators and the beep off. Notes ▯ To set a cooking time of under 10 minutes, always touch 0 before you select the required value. ▯ If a cooking time was set for several elements, the time information for the selected element is shown in the timer display. ▯ Select the relevant element to call up the remaining cooking time. ▯ You can set a cooking time of up to ŠŠ minutes. Automatic timer With this function you may select a cook time for all elements. Once an element is turned on, the selected time will begin to count down. The element will automatically turn off when the cook time has elapsed. Instructions on activating the automatic timer are found in the chapter "Basic settings". Note: The cook time can be changed or cancelled for any element: Select the desired element. Touch the TIMER key. Adjust the cook time using the number keys, or deactivate it by setting the timer value to ‹. Kitchen timer The timer can be set for periods of up to 99 minutes. It is independent of the other settings. You can also use the kitchen timer when the cooktop is turned off or locked. This function does not automatically switch off an element. Setting the kitchen timer 1. Touch the TIMER key until the V indicator lights up. ‹‹ appears on the timer display. 2. Set the desired time using the number keys. min appears on the timer display. The timer start to count down after a few seconds. Changing or deleting the time Touch the TIMER key repeatedly until the V indicator lights up. Change the time using number keys, or set ‹‹ in order to delete the programmed time. When the time has elapsed A beep sounds. ‹‹ appears on the timer display and the V indicator lights up. The displays go out after 10 seconds. Touch any key to turn off the indicators and the beep. 14 Panel lock You can use the panel lock to prevent children from accidentally turning the cooktop on. Turning the panel lock on The cooktop must be turned off. Touch LOCK for 4 seconds. The Ú indicator lights up for several seconds. The cooktop is now locked. Turning the panel lock off Touch LOCK for 4 seconds. The cooktop is now unlocked. 9 CAUTION The panel lock may be accidentally turned on and off due to: ▯ water spilled during cleaning ▯ food that has overflowed ▯ objects being placed on the LOCK touch key. Automatic panel lock With this function, the panel lock is automatically activated whenever you switch off the cooktop. Turning on and off See "Basic settings" section. Wipe Protection Cleaning the control panel while the cooktop is on may change the settings. In order to avoid this the cooktop has a wipe protection function. To activate: Touch the LOCK key. The Ú indicator above the key lights up. The control panel is locked for 35 seconds. You can now clean the surface of the control panel without risk of changing the settings. To deactivate: To deactivate the function before the time has elapsed, touch the LOCK key. The Ú indicator above the key turns off, the function is deactivated. Notes ▯ An acoustic signal sounds 30 seconds after activation. This indicates that the function is about to finish. ▯ The wipe protection lock does not lock the main switch. The cooktop can be switched off at any time. Automatic time limitation If the element is used for prolonged periods of time without changes in the settings being made, the automatic time limitation function is triggered. The element stops heating. "‰ and the residual heat indicator •/œ flash alternately in the display. The indicator goes out when any symbol is pressed. The element can now be reset. When the automatic time limitation is activated depends on the selected heat level (from 1 to 10 hours).