Thermador PRG364WLG Installation Instructions - Page 23
Low backguard installation, optional
![]() |
View all Thermador PRG364WLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Low backguard installation (optional) 2. Remove the drill point screws securing the piece to the back panel. Lift up to fully remove. 9 WARNING Fingers or hands could get pinched when installing the backguard. Severe injury could result. Use extreme caution and wear thick protective gloves to avoid potential laceration to finger or hand while sliding the backguard down onto the range. 9 WARNING To reduce the risk of fire or injury to persons, ensure all packaging has been removed from accessory devices before use. Installation methods will vary upon need. Before you begin read these instructions carefully. Observe all local codes and ordinances. To install the low backguard 1. Remove the T-20 torx stainless screws in the front face of the included island trim. 3. Align the back panel of the new accessory with the flanges on the range side panels right and left rear corners. Make sure the backguard front face is outside the flange on the front side of the range. 4. Reinstall screws removed in Steps 1 and 2. Page. 22
![](/manual_guide/products/thermador-prd48wcsgu-installation-instructions-4fe10d2/23.png)