Thermador PRG364WLG Installation Instructions - Page 26
Burner test
View all Thermador PRG364WLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Burner test 9 WARNING To prevent flare-ups and avoid the creation of harmful by-products, do not use the cooktop without all burner caps and all burner grates properly positioned. 9 WARNING To prevent burns, do not touch burner caps or grates while hot. Turn the cooktop off and allow the burners to cool. Install any loose components, such as burner caps and grates that may have been removed earlier. Be certain that burner caps seat properly into the burner bases. Before testing operation of the appliance, verify that the unit and the gas supply have been carefully checked for leaks and that the unit has been connected to the electrical power supply. Turn the manual gas shut-off valve to the open position. The burner caps must be properly placed on the burner bases for the cooktop to function properly. If the burner cap is not properly placed, one or more of the following problems may occur: • Burner flames are too high. • Flames shoot out of burners. • Burners do not ignite. • Burner flames light unevenly. • Burner emits gas odor. Burner cap placement Each cap has a letter (B, D, or F) cast in the underside of the cap that corresponds to a letter (B, D, or F) cast in the burner base that is attached to the appliance. 2. Place burner cap gently on top of base so that the prongs of the burner base fit snugly into the groove of the burner cap. Checking the burner cap placement • Check each burner to make sure there is no gap between the burner cap and burner base. • You may gently try to move the burner caps from side to side to check if the caps are properly placed on the burner bases. • When properly placed, each burner cap will rest flat on top of its burner base, and completely cover the star-shape of the burner base when viewed from the top as shown below. Burner grate placement To install the burner grates 1. Place grates flat-side down and align into the rangetop recess. 2. Grates should rest flush against each other and against the sides of the recess. To place the burner caps 1. Place each burner cap on its correct burner base per its corresponding letter designation. Page. 25