Toshiba 27AF44 User Manual - Page 12

To control a cable TV CABLE converter: Power Program the remote control to recognize the brand of your converter Channel (see "Programming the Numbers remote control for use with a VCR, DVD player, or cable TV converter" below). The buttons Channel +/- shown at right will control the cable TV converter. CH Enter Press the CABLE button first. POWER TV 12 45 VCR CABLE DVD 3 +10 6 100 7890 CH + VOL VOL - MENU/ ENTER + CH - EXIT RECALL TV/VIDEO FAV VOL CH RTN FAV RESET CAP/TEXT 1/2 16:9 DISPLAY DVD CLEAR TOP MENU DVD MENU CODE MTS SLEEP MUTE REW PLAY FF TV/VCR STOP PAUSE/STILL REC VCR CH DVD SKIP Using the Remote Control Programming the remote control for use with a VCR, DVD player, or cable TV converter This remote control is pre-programmed to operate Toshiba VCRs and DVD players. To control VCRs, DVD players, or cable converters other than Toshiba models, you must follow the steps below to program your remote control. 1. While holding down the CODE button, press the button for the device you want to control (VCR, DVD, or CABLE). 2. Enter the 2-digit code listed on page 13 using the Number buttons (0-9) within 10 seconds. 3. Point the remote control at the VCR, DVD player, or converter and press POWER to test the code. If the VCR, DVD player, or converter turns on, you have entered the right code. If the VCR, DVD player, or converter does not respond to the remote control, you may have entered the wrong code. Repeat steps 1~2 with another code. For future reference, write down the codes you used: VCR code DVD player code Cable TV converter code 12 POWER TV 12 45 VCR CABLE DVD 3 +10 6 100 7890 CH + VCR CABLE DVD VOL VOL - MENU/ ENTER + EXIT CH - RECALL TV/VIDEO FAV VOL CH RTN FAV RESET CAP/TEXT 1/2 16:9 DISPLAY DVD CLEAR TOP MENU DVD MENU CODE MTS SLEEP MUTE REW PLAY FF Code Notes: • When shipped from the factory, the remote control is set to operate your TV. • If you do not enter the code within 10 seconds from step 1 or if you enter a code not listed below, this operation is canceled. • Each time you replace the batteries, you must reprogram the remote control. • Some newer VCRs are capable of working on either of two remote codes. These VCRs have a switch labeled "VCR1/VCR2." If your VCR has this kind of switch and does not respond to any of the codes for your VCR, set the switch to the other position (VCR1 or VCR2) and reprogram the remote control. 3N11501A[E] P07-16 12 8/1/18, 12:25