Toshiba 62HM196 Installation Guide - English - Page 16

DLP_Inst.book Page 16 Wednesday, February 22, 2006 6:18 PM Connecting your TV Connecting a digital audio system The TV's DIGITAL AUDIO OUT terminal outputs a Dolby®* Digital g or 2-channel down-mixed PCM (pulse-code modulation) signal for use with an external Dolby® Digital decoder or other external audio system with optical audio input. You will need: • optical audio cable (Use an optical audio cable that has the larger "TosLink" connector and not the smaller "minioptical" connector.) Dolby Digital decoder or other digital audio system LINE IN LR Optical Audio IN 5 Turn off the TV's built-in speakers in the same Audio Setup menu. Also see "Turning off the built-in speakers" in the Operating Guide. Notes: • Some audio systems may not be compatible with Dolby Digital bitstream signals. Older audio systems that are not compatible with standard optical out signals may not work properly, creating a high noise level that may damage speakers or headphones. THIS DAMAGE IS NOT COVERED BY YOUR WARRANTY. • The DIGITAL AUDIO OUT terminal outputs signals only when receiving digital broadcasts with the TV in singlewindow mode. • The DIGITAL AUDIO OUT terminal may not output some digital audio sources because of copy restrictions. * Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are registered trademarks of Dolby Laboratories. TV Connecting an analog audio system This connection allows you to use external speakers with an external analog audio amplifier to adjust the sound level. You will need: • standard audio cables Analog audio amplifier LINE IN To control the audio: LR 1 Turn on the TV and the digital audio device. 2 Press MENU on the TV's remote control and open the TV Audio menu. 3 Highlight Audio Setup and press ENTER. Audio Audio Settings Advanced Audio Settings Audio Setup 4 In the Optical Output Format field, select either Dolby Digital or PCM, depending on your device (- "Selecting the optical audio output format" in the Operating Guide). Audio Setup MTS Language Speakers Optical Output Format Stereo English On Dolby Digital Reset Done To control the audio: 1 Turn on the TV and the stereo amplifier. 2 Turn off the TV's built-in speakers (- "Turning off the built-in speakers" in the Operating Guide). Note: To hear sound when using an external audio amplifier, the volume of both the TV and the amplifier must be set to a reasonable listening level. 16 DLP Inst (E/F) Web 213:276