Toshiba BDX2000 Owner's Manual - English - Page 47

E5PJ1UD_EN.book Page 47 Thursday, September 10, 2009 6:45 PM INTRODUCTION CONNECTIONS PLAYBACK FUNCTION SETUP OTHERS FUNCTION SETUP If you select "Manual", follow the following instruction to set the IP address and DNS. 3-a) Use [K / L] to select "IP Address", "Subnet Mask" or "Default Gateway", then press [ENTER]. IP address setting screen will appear. Enter IP address, subnet mask and default gateway with cursor buttons and number buttons. Others IP Address Setting IP Address xxx . xxx . xxx . xxx Subnet Mask xxx . xxx . xxx . xxx Default Gateway xxx . xxx . xxx . xxx then press 'ENTER' 3-d) After you enter all correctly, press [ENTER]. • Confirmation message will appear. Select "Yes" to complete the settings. Others DNS Setting Is Setting OK? Primary DNS Secondary DNS xxx . xxx . xxx . xxx xxx . xxx . xxx . xxx No Yes 4 Press [RETURN] to go back to the previous screen, or press [SETUP] to exit. • Enter the IP address number after checking the specifications of your router. • If the IP address number is unknown, check the IP address number of other devices (e.g. PC connected via LAN cable) and assign a different number from those of other devices. 3-b) After you enter all correctly, press [ENTER]. • Confirmation message will appear. Select "Yes" to complete the settings. Others IP Address Setting Is Setting OK? IP Address Subnet Mask Default Gateway No Yes xxx . xxx . xxx . xxx xxx . xxx . xxx . xxx xxx . xxx . xxx . xxx Note • The range of input number is between 0 and 255. • If you enter a number larger than 255, the number will automatically be 255. • The manually entered number will be saved even if you change the setting to "Auto(DHCP)". • When you enter a wrong number, press [CLEAR] to cancel. (The number will be back to "0".) • If you want to enter 1 or 2 digit number in one cell, press [B] to move on to the next cell. • If the entered IP address or the default gateway or primary DNS number is same as the default setting, IP address setting will be set to "Auto(DHCP)". (The manually entered number will be saved.) • When IP address setting is set to "Manual", the setting of DNS setting will automatically be "Manual" and when IP address setting is set to "Auto(DHCP)", you can set either "Auto(DHCP)" or "Manual" for DNS setting. • Proxy Setting 3-c) Use [K / L] to select "Primary DNS" or "Secondary DNS", then press [ENTER]. DNS setting screen will appear. Enter primary DNS and secondary DNS with cursor buttons and number buttons. 1 Follow steps 1 to 4 in "Connection Test" on page 46. 2 Use [K / L] to select "Enable(Custom)", then press [ENTER]. Others DNS Setting Primary DNS xxx . xxx . xxx . xxx Secondary DNS xxx . xxx . xxx . xxx then press 'ENTER' 3 Use [K / L] to select "Proxy Setting", then press [ENTER] repeatedly to select the desired setting. • For default settings, select "Do Not Use". • If you need to change the proxy setting as instructed by your Internet service provider to set the designated proxy address and port, select "Use". If you select "Use", follow the following instructions to set the proxy address and proxy port. • Enter the numbers instructed by your Internet provider. • If the number is unknown, check the number of other devices (e.g. PC connected via LAN cable) and assign the same number. EN 47