Toshiba RS-TX60 User Guide - Page 145
I can't go to one of my channels.
View all Toshiba RS-TX60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Questions About Channels • You may consider optimizing the IR Control connection as described on page 9. • Press the TiVo button to go to TiVo Central, then select Messages & Setup, then Cable/Satellite Box, then Control Cable Setup. Verify the IR code you chose during Guided Setup. See page 6 for more on choosing an IR code. • Try using the cable or satellite box's remote to change the channel. If it doesn't work, contact the manufacturer or service provider. If you have a Motorola/General Instruments DCT2000 series cable box or a DIRECTV® satellite box and used the Serial Control cable: • Make sure the cable or satellite box is turned on. • Verify that the Serial Control cable is plugged into the data connector on the cable or satellite box and into the Control Out-Serial jack on the back of the DMS. • Unplug the cable or satellite box's power cord, then plug it back in. Then try changing channels with the TiVo remote again. • Try using the cable or satellite box's remote to change the channel. If it doesn't work, contact the manufacturer or service provider. • Serial control of a Motorola/General Instruments DCT2000 series cable box may not be available for all customers. Check with your cable provider to find out if your cable box is enabled for serial control. • Satellite Box Only: You may have incorrectly specified the type of program guide for your DIRECTV satellite box. There are two types of program guides: MPG (Master Program Guide) and APG (Advanced Program Guide). To change this option: First, unplug the power cord for the satellite box, wait a few seconds, then plug it back in. Next, go to TiVo Central, then Message & Setup, then Settings, the TiVo DMS Setup, then Cable/Satellite Box, then Satellite Channel Changing and select "Satellite Box." On the Connection to Satellite screen, if you originally selected Serial-MPG, change your selection to SerialAPG. (If you originally selected Serial-APG, change it to Serial-MPG.) You can also check the manual for your satellite box (as well as the satellite box's system setup screen) for information on the type of program guide it uses. I can't go to one of my channels. • You may be using a channel list that does not include the channel you want. Use the numbers on the remote control to enter the channel number, then press ENTER. For more information on using a channel list, see page 68. 9 137 Downloaded from www.Manualslib.com manuals search engine